8 material differences · fewer than 12
Tractor oneIMT 5130/51361982–1992No measured PTO figureTractor twoSOMECA 1300 (TD)1974–1977No measured PTO figure
Which should you choose?
Read our verdict on the 5130/5136 and the 1300 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 5130/5136 | 1300 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 133.2 hp | 128.2 hp | — |
| Engine declared | IMR-PERKINS TS 46/T (T 6.354.4) | O.M.-FIAT CP-3/100 Var.16 | differs |
| Displacement declared | 5.80 L | 7.41 L | +28% 1300 (TD) |
| Maximum torque declared | 304 lb·ft · 412 N·m | 356 lb·ft · 482 N·m | +17% 1300 (TD) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 5130/5136 |
| Clutch declared | — | Pedal operated dry FERODO single disc clutch 14 inch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.2 gpm · 38.8 L/min | 12.6 gpm · 47.7 L/min | +23% 1300 (TD) |
| Pressure declared | — | 2,901–3,336 psi · 200–230 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 11,718 lb · 5,315 kg | 12,456 lb · 5,650 kg | +6% 1300 (TD) |
| Wheelbase declared | 108.3 in · 2,750 mm | 108.3 in · 2,750 mm | — |
| Length declared | 178.0 in · 4,521 mm | 175.6 in · 4,460 mm | — |
| Width declared | 82.7 in · 2,100 mm | 85.4–109.1 in · 2,170–2,770 mm | differs |
| Ground clearance declared | 18.1 in · 460 mm | 25.0 in · 635 mm | +38% 1300 (TD) |
| Turning radius, braked declared | 14.0 ft · 4.28 m | 14.4 ft · 4.40 m | — |
| Fuel tank declared | 227.2 qt · 215.0 L | 216.6 qt · 205.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
IMT 5130/5136 sources
- Source: Traktorenlexikon, “IMT 5130/5136”
SOMECA 1300 (TD) sources
- Source: Traktorenlexikon, “Someca 1300”