9 material differences · fewer than 12
Tractor oneIMT 5130/51361982–1992No measured PTO figureTractor twoInternational Harvester Farmall 12561967–1969No measured PTO figure
Which should you choose?
Read our verdict on the 5130/5136 and the Farmall 1256 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 5130/5136 | Farmall 1256 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 133.2 hp | 116.4 hp | +14% 5130/5136 |
| Engine declared | IMR-PERKINS TS 46/T (T 6.354.4) | INTERNATIONAL HARVESTER DT-407 | differs |
| Displacement declared | 5.80 L | 6.67 L | +15% Farmall 1256 |
| Maximum torque declared | 304 lb·ft · 412 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Pedal operated dry single plate clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.2 gpm · 38.8 L/min | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 11,718 lb · 5,315 kg | 10,406 lb · 4,720 kg | +13% 5130/5136 |
| Wheelbase declared | 108.3 in · 2,750 mm | 104.8 in · 2,662 mm | — |
| Length declared | 178.0 in · 4,521 mm | 164.0 in · 4,166 mm | +9% 5130/5136 |
| Width declared | 82.7 in · 2,100 mm | 92.0 in · 2,337 mm | +11% Farmall 1256 |
| Ground clearance declared | 18.1 in · 460 mm | 23.5 in · 597 mm | +30% Farmall 1256 |
| Turning radius, braked declared | 14.0 ft · 4.28 m | 10.9 ft · 3.33 m | +29% 5130/5136 |
| Fuel tank declared | 227.2 qt · 215.0 L | 168.0 qt · 159.0 L | +35% 5130/5136 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
IMT 5130/5136 sources
- Source: Traktorenlexikon, “IMT 5130/5136”
International Harvester Farmall 1256 sources
- Source: Traktorenlexikon, “Farmall Farmall 1256”
- Source: Traktorenlexikon, “IHC 1026”