8 material differences · fewer than 12
Tractor oneIMT 5130/51361982–1992No measured PTO figureTractor twoInternational Harvester Farmall 10661971–1976No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD); they were not built in overlapping years (1982–1992; 1971–1976). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 5130/5136 | Farmall 1066 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 133.2 hp | 115.5 hp | +15% 5130/5136 |
| Engine declared | IMR-PERKINS TS 46/T (T 6.354.4) | INTERNATIONAL HARVESTER DT-414 | differs |
| Displacement declared | 5.80 L | 6.78 L | +17% Farmall 1066 |
| Maximum torque declared | 304 lb·ft · 412 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.2 gpm · 38.8 L/min | 12.0 gpm · 45.5 L/min | +17% Farmall 1066 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 11,718 lb · 5,315 kg | 12,145 lb · 5,509 kg | — |
| Wheelbase declared | 108.3 in · 2,750 mm | 104.8 in · 2,662 mm | — |
| Length declared | 178.0 in · 4,521 mm | 165.0 in · 4,191 mm | +8% 5130/5136 |
| Width declared | 82.7 in · 2,100 mm | 98.0 in · 2,489 mm | +19% Farmall 1066 |
| Ground clearance declared | 18.1 in · 460 mm | 16.0 in · 406 mm | +13% 5130/5136 |
| Turning radius, braked declared | 14.0 ft · 4.28 m | 12.0 ft · 3.66 m | +17% 5130/5136 |
| Fuel tank declared | 227.2 qt · 215.0 L | 168.0 qt · 159.0 L | +35% 5130/5136 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
IMT 5130/5136 sources
- Source: Traktorenlexikon, “IMT 5130/5136”
International Harvester Farmall 1066 sources
- Source: Traktorenlexikon, “IHC 1066”
- Source: Traktorenlexikon, “Farmall Farmall 1066”