Hürlimann H-80 XA or New Holland TLA 80 (A)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the H-80 XA has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TLA 80 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The New Holland TLA 80 (A) suits loader and hydraulic implement work better on this data: 96% (30.5 L/min / 8.1 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Hürlimann H-80 XA and New Holland TLA 80 (A), with the call on each
QuestionH-80 XATLA 80 (A)Call
Which puts more power through the PTO shaft?60.3 kW (80.9 hp)Traktorenlexikon, “Hürlimann XA 80”60.3 kW (80.9 hp)Traktorenlexikon, “New Holland TL 80 A (2004-2008)”Not comparableNot comparable on power at the PTO shaft: the H-80 XA has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TLA 80 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the H-80 XA and the TLA 80 (A).
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the H-80 XA and the TLA 80 (A).
Which pumps more oil for implements?31.9 L/min (8.4 gpm)Traktorenlexikon, “Hürlimann XA 80”62.4 L/min (16.5 gpm)Traktorenlexikon, “New Holland TL 80 A (2004-2008)”AheadThe New Holland TLA 80 (A) has 96% more hydraulic flow (30.5 L/min / 8.1 gpm) than the Hürlimann H-80 XA (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?3,000 kg (6,614 lb)Traktorenlexikon, “Hürlimann XA 80”—No figureNo call on three-point lift: no figure on record for the TLA 80 (A).
Which is heavier, for traction?2,900 kg (6,393 lb)Traktorenlexikon, “Hürlimann XA 80”3,840 kg (8,466 lb)Traktorenlexikon, “New Holland TL 80 A (2004-2008)”Ahead (a fact, not an advantage)The New Holland TLA 80 (A) is 32% heavier (940 kg / 2,072 lb) than the Hürlimann H-80 XA (both unladen weight, as stated by the source).
Which may carry more ballast and load?5,000 kg (11,023 lb)Traktorenlexikon, “Hürlimann XA 80”5,500 kg (12,125 lb)Traktorenlexikon, “New Holland TL 80 A (2004-2008)”EvenEven on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
Which has the wider choice of gears?30 to 45Traktorenlexikon, “Hürlimann XA 80”12 to 24Traktorenlexikon, “New Holland TL 80 A (2004-2008)”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?—YesTraktorenlexikon, “New Holland TL 80 A (2004-2008)”No figureNo call on a creeper range: not stated for the H-80 XA.
Which is faster on the road?40 km/h (24.9 mph) to 50 km/h (31.1 mph)Traktorenlexikon, “Hürlimann XA 80”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “New Holland TL 80 A (2004-2008)”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540 rpm / 1000 rpmTraktorenlexikon, “Hürlimann XA 80”540/540E/1000 rpmTraktorenlexikon, “New Holland TL 80 A (2004-2008)”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?—independentTraktorenlexikon, “New Holland TL 80 A (2004-2008)”No figureNo call on PTO independence: not stated for the H-80 XA.
Which drives on both axles?4WDTraktorenlexikon, “Hürlimann XA 80”Two-wheel or four-wheel driveTraktorenlexikon, “New Holland TL 80 A (2004-2008)”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?2009–20142004–2008Ahead (a fact, not an advantage)The Hürlimann H-80 XA is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The New Holland TLA 80 (A) has 96% more hydraulic flow (30.5 L/min / 8.1 gpm) than the Hürlimann H-80 XA (both pump flow, as stated by the source).
  • The New Holland TLA 80 (A) is 32% heavier (940 kg / 2,072 lb) than the Hürlimann H-80 XA (both unladen weight, as stated by the source).
  • The Hürlimann H-80 XA is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the H-80 XA has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the TLA 80 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources