10 material differences · fewer than 12
Tractor oneHürlimann H-6160 A1979–1983No measured PTO figureTractor twoInternational Harvester Farmall 14681971–1974No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (4WD; 2WD); they were not built in overlapping years (1979–1983; 1971–1974). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | H-6160 A | Farmall 1468 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 155.7 hp | 146.0 hp | +7% H-6160 A |
| Engine declared | Hürlimann H-1106/15-Turbo | INTERNATIONAL HARVESTER DV-8/550 | differs |
| Displacement declared | 6.84 L | 8.99 L | +31% Farmall 1468 |
| Maximum torque declared | 471 lb·ft · 638 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 21.7 mph · 35 km/h | +40% Farmall 1468 |
| Clutch declared | — | Pedal operated ceramic clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 15.3 gpm · 58.0 L/min | 12.0 gpm · 45.5 L/min | +27% H-6160 A |
| Pressure declared | 2,277 psi · 157 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 14,220 lb · 6,450 kg | 13,459 lb · 6,105 kg | +6% H-6160 A |
| Maximum permissible mass declared | 20,503 lb · 9,300 kg | — | — |
| Wheelbase declared | 112.5 in · 2,857 mm | 104.8 in · 2,662 mm | +7% H-6160 A |
| Length declared | 175.2 in · 4,450 mm | 168.0 in · 4,267 mm | — |
| Width declared | 92.5 in · 2,350 mm | 98.0 in · 2,489 mm | +6% Farmall 1468 |
| Ground clearance declared | 19.3 in · 490 mm | 16.0 in · 406 mm | +21% H-6160 A |
| Turning radius, braked declared | — | 11.7 ft · 3.56 m | — |
| Fuel tank declared | 253.6 qt · 240.0 L | 168.0 qt · 159.0 L | +51% H-6160 A |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann H-6160 A sources
- Source: Traktorenlexikon, “Hürlimann H 6160”
International Harvester Farmall 1468 sources
- Source: Traktorenlexikon, “Farmall Farmall 1468”
- Source: Traktorenlexikon, “IHC 1568”
- Source: Traktorenlexikon, “IHC 1468”