7 material differences · fewer than 12

Tractor oneHürlimann H-490 (A)1979–1983No measured PTO figureTractor twoSAME Panter (DT)1973–1977No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (27%); they were not built in overlapping years (1979–1983; 1973–1977). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

7 material differences · 4 fields identical or within 5%, which is not counted as material

Hürlimann H-490 (A) and SAME Panter (DT), field by field
FieldH-490 (A)Panter (DT)Gap
Engine
Engine power, claimed claimed88.8 hp82 hp+9% H-490 (A)
Engine declaredHürlimann H-1104/8 or H-1104/8-TurboSAME DA 985 Pdiffers
Displacement declared4.56 L4.52 L—
Maximum torque declared260 lb·ft · 352 N·m203 lb·ft · 275 N·m+28% H-490 (A)
Transmission
Top speed declared15.5–18.6 mph · 25–30 km/h15.5 mph · 25 km/hdiffers
Clutch declaredDry SAME double clutch——
Hydraulics & hitch
Pump flow declared—8.4 gpm · 31.7 L/min—
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared8,929–10,020 lb · 4,050–4,545 kg7,033 lb · 3,190 kgdiffers
Maximum permissible mass declared14,551 lb · 6,600 kg——
Wheelbase declared96.7 in · 2,457 mm98.4 in · 2,499 mm—
Length declared166.5 in · 4,230 mm161.4 in · 4,100 mm—
Width declared81.5–101.2 in · 2,070–2,570 mm76.0–79.9 in · 1,930–2,030 mmdiffers
Ground clearance declared13.8 in · 350 mm23.6 in · 600 mm+71% Panter (DT)
Turning radius, braked declared—10.8 ft · 3.30 m—
Fuel tank declared169.1 qt · 160.0 L95.1 qt · 90.0 L+78% H-490 (A)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Hürlimann H-490 (A) sources

Source
  • Source: Traktorenlexikon, “Hürlimann H 490”

SAME Panter (DT) sources

Source
  • Source: Traktorenlexikon, “SAME Panther”