Hürlimann H-478 "Prestige" or SAME Silver 80 (DT)?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Hürlimann H-478 "Prestige" and SAME Silver 80 (DT), with the call on each
QuestionH-478 "Prestige"Silver 80 (DT)Call
Which puts more power through the PTO shaft?54.3 kW (72.8 hp)Traktorenlexikon, “Hürlimann H 478 Prestige”54.8 kW (73.5 hp)Traktorenlexikon, “SAME Silver 80”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the H-478 "Prestige" and the Silver 80 (DT).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the H-478 "Prestige" and the Silver 80 (DT).
Which pumps more oil for implements?40.5 L/min (10.7 gpm)Traktorenlexikon, “Hürlimann H 478 Prestige”39.8 L/min (10.5 gpm)Traktorenlexikon, “SAME Silver 80”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?2,705 kg (5,964 lb)Traktorenlexikon, “Hürlimann H 478 Prestige”3,600 kg (7,937 lb)Traktorenlexikon, “SAME Silver 80”Not comparableNot comparable on three-point lift: the H-478 "Prestige": lift through the full range at the hitch ends, as stated by the source (Traktorenlexikon, “Hürlimann H 478 Prestige”); the Silver 80 (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “SAME Silver 80”) — not the same quantity, basis and condition.
Which is heavier, for traction?3,395 kg (7,485 lb)Traktorenlexikon, “Hürlimann H 478 Prestige”3,600 kg (7,937 lb)Traktorenlexikon, “SAME Silver 80”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?6,000 kg (13,228 lb)Traktorenlexikon, “SAME Silver 80”No figureNo call on maximum permissible mass: no figure on record for the H-478 "Prestige".
Which has the wider choice of gears?20Traktorenlexikon, “Hürlimann H 478 Prestige”15 to 60Traktorenlexikon, “SAME Silver 80”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the H-478 "Prestige" and the Silver 80 (DT).
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Hürlimann H 478 Prestige”40 km/h (24.9 mph)Traktorenlexikon, “SAME Silver 80”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Hürlimann H 478 Prestige”540/540E/1000E/1000 rpmTraktorenlexikon, “SAME Silver 80”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “SAME Silver 80”No figureNo call on PTO independence: not stated for the H-478 "Prestige".
Which drives on both axles?4WDTraktorenlexikon, “Hürlimann H 478 Prestige”Two-wheel or four-wheel driveTraktorenlexikon, “SAME Silver 80”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1989–19981995–2004Ahead (a fact, not an advantage)The SAME Silver 80 (DT) is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The SAME Silver 80 (DT) is newer: production began 6 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on three-point lift: the H-478 "Prestige": lift through the full range at the hitch ends, as stated by the source (Traktorenlexikon, “Hürlimann H 478 Prestige”); the Silver 80 (DT): lift at the hitch ends, as stated by the source (Traktorenlexikon, “SAME Silver 80”) — not the same quantity, basis and condition.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources