Hürlimann H-305 XE or SAME Argon 50 (DT)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the H-305 XE has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Argon 50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Hürlimann H-305 XE and SAME Argon 50 (DT), with the call on each
QuestionH-305 XEArgon 50 (DT)Call
Which puts more power through the PTO shaft?36.8 kW (49.3 hp)Traktorenlexikon, “Hürlimann XE 305”36.8 kW (49.3 hp)Traktorenlexikon, “SAME Argon 50”Not comparableNot comparable on power at the PTO shaft: the H-305 XE has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Argon 50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the H-305 XE and the Argon 50 (DT).
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the H-305 XE and the Argon 50 (DT).
Which pumps more oil for implements?31.3 L/min (8.3 gpm)Traktorenlexikon, “Hürlimann XE 305”33.0 L/min (8.7 gpm)Traktorenlexikon, “SAME Argon 50”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?—2,900 kg (6,393 lb)Traktorenlexikon, “SAME Argon 50”No figureNo call on three-point lift: no figure on record for the H-305 XE.
Which is heavier, for traction?2,290 kg (5,049 lb)Traktorenlexikon, “Hürlimann XE 305”2,090 kg (4,608 lb)Traktorenlexikon, “SAME Argon 50”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?—3,900 kg (8,598 lb)Traktorenlexikon, “SAME Argon 50”No figureNo call on maximum permissible mass: no figure on record for the H-305 XE.
Which has the wider choice of gears?12 to 16Traktorenlexikon, “Hürlimann XE 305”16 to 24Traktorenlexikon, “SAME Argon 50”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?—YesTraktorenlexikon, “SAME Argon 50”No figureNo call on a creeper range: not stated for the H-305 XE.
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Hürlimann XE 305”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “SAME Argon 50”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540 rpm / 1000 rpmTraktorenlexikon, “Hürlimann XE 305”540/540E rpmTraktorenlexikon, “SAME Argon 50”AheadThe Hürlimann H-305 XE offers 1000 rpm at the PTO, which the SAME Argon 50 (DT) does not (as stated by the sources).
Which PTO runs independently of the ground drive?—independentTraktorenlexikon, “SAME Argon 50”No figureNo call on PTO independence: not stated for the H-305 XE.
Which drives on both axles?4WDTraktorenlexikon, “Hürlimann XE 305”Two-wheel or four-wheel driveTraktorenlexikon, “SAME Argon 50”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1993–20041993–2004EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Hürlimann H-305 XE offers 1000 rpm at the PTO, which the SAME Argon 50 (DT) does not (as stated by the sources).
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the H-305 XE has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the Argon 50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources