9 material differences · fewer than 12
Tractor oneHürlimann DH-61969–1970No measured PTO figureTractor twoSOMECA 1300 Super (DT)1978–1981No measured PTO figure
Which should you choose?
Read our verdict on the DH-6 and the 1300 Super (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | DH-6 | 1300 Super (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 143.0 hp | 143.0 hp | — |
| Engine declared | Hürlimann DH-6 | O.M.-FIAT CP-3/100 Var.17 | differs |
| Displacement declared | 9.19 L | 7.41 L | +24% DH-6 |
| Maximum torque declared | 398 lb·ft · 539 N·m | 348 lb·ft · 472 N·m | +14% DH-6 |
| Transmission | |||
| Top speed declared | 12.4–37.3 mph · 20–60 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | — | Pedal-operated dry Ferodo single-plate clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 12.0 gpm · 45.5 L/min | — |
| Pressure declared | — | 2,901–3,336 psi · 200–230 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 13,999 lb · 6,350 kg | 11,155 lb · 5,060 kg | +25% DH-6 |
| Wheelbase declared | 118.1 in · 3,000 mm | 108.3 in · 2,750 mm | +9% DH-6 |
| Length declared | 187.0 in · 4,750 mm | 187.8 in · 4,770 mm | — |
| Width declared | 81.9 in · 2,080 mm | 85.4–109.1 in · 2,170–2,770 mm | differs |
| Ground clearance declared | — | 26.0 in · 660 mm | — |
| Turning radius, braked declared | — | 14.4 ft · 4.40 m | — |
| Fuel tank declared | 126.8 qt · 120.0 L | 216.6 qt · 205.0 L | +71% 1300 Super (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann DH-6 sources
- Source: Traktorenlexikon, “Hürlimann DH 6”
SOMECA 1300 Super (DT) sources
- Source: Traktorenlexikon, “Someca 1300 S”