Hürlimann D-65 Spezial or Hürlimann D-70 Super-Spezial?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Hürlimann D-65 Spezial and Hürlimann D-70 Super-Spezial, with the call on each
QuestionD-65 SpezialD-70 Super-SpezialCall
Which puts more power through the PTO shaft?31.0 kW (41.5 hp)Traktorenlexikon, “Hürlimann D 65”31.0 kW (41.5 hp)Traktorenlexikon, “Hürlimann D 70 SSP”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the D-65 Spezial and the D-70 Super-Spezial.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the D-65 Spezial and the D-70 Super-Spezial.
Which pumps more oil for implements?——No figureNo call on hydraulic flow: no figure on record for the D-65 Spezial and the D-70 Super-Spezial.
Which lifts more on the three-point hitch?1,100 kg (2,425 lb)Traktorenlexikon, “Hürlimann D 65”1,100 kg (2,425 lb)Traktorenlexikon, “Hürlimann D 70 SSP”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?1,525 kg (3,362 lb)Traktorenlexikon, “Hürlimann D 65”1,530 kg (3,373 lb)Traktorenlexikon, “Hürlimann D 70 SSP”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the D-65 Spezial and the D-70 Super-Spezial.
Which has the wider choice of gears?7Traktorenlexikon, “Hürlimann D 65”7Traktorenlexikon, “Hürlimann D 70 SSP”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?YesTraktorenlexikon, “Hürlimann D 65”YesTraktorenlexikon, “Hürlimann D 70 SSP”EvenEven on a creeper range: every machine offers one.
Which is faster on the road?20 km/h (12.4 mph)Traktorenlexikon, “Hürlimann D 65”20 km/h (12.4 mph)Traktorenlexikon, “Hürlimann D 70 SSP”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Hürlimann D 65”540 rpmTraktorenlexikon, “Hürlimann D 70 SSP”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?dependent (stops with the clutch)Traktorenlexikon, “Hürlimann D 65”dependent (stops with the clutch)Traktorenlexikon, “Hürlimann D 70 SSP”EvenEven on PTO independence: every PTO is dependent.
Which drives on both axles?2WDTraktorenlexikon, “Hürlimann D 65”2WDTraktorenlexikon, “Hürlimann D 70 SSP”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1958–19661958–1966EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on a creeper range: every machine offers one.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on PTO independence: every PTO is dependent.
  • Even on drive: all two-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow and maximum permissible mass.

← Every figure for both machines, side by side, with sources