11 material differences · fewer than 12
Tractor oneHürlimann D-4101960–1964No measured PTO figureTractor twoSOMECA 670 (DT)1968–1971No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (31%); the drive differs (2WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1960–1964; 1968–1971). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D-410 | 670 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 64 hp | 64.1 hp | — |
| Engine declared | Hürlimann D-120 | O.M.-FIAT CO 3/60 | differs |
| Displacement declared | 4.43 L | 4.56 L | — |
| Maximum torque declared | — | 207 lb·ft · 281 N·m | — |
| Transmission | |||
| Top speed declared | 13.7–37.3 mph · 22–60 km/h | 14.9 mph · 24 km/h | differs |
| Clutch declared | — | Pedal-operated two-stage dry FEREDO double clutch type 11/10" | — |
| Hydraulics & hitch | |||
| Pump flow declared | 9.5 gpm · 36.0 L/min | 6.1 gpm · 23.2 L/min | +55% D-410 |
| Pressure declared | 2,560 psi · 177 bar | 2,843 psi · 196 bar | +11% 670 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,937 lb · 3,600 kg | 6,041 lb · 2,740 kg | +31% D-410 |
| Wheelbase declared | 84.3 in · 2,140 mm | 91.2 in · 2,316 mm | +8% 670 (DT) |
| Length declared | 128.7 in · 3,270 mm | 142.3 in · 3,615 mm | +11% 670 (DT) |
| Width declared | 71.7 in · 1,820 mm | 77.6–96.1 in · 1,970–2,440 mm | differs |
| Ground clearance declared | 10.4 in · 265 mm | 13.4 in · 340 mm | +28% 670 (DT) |
| Turning radius, braked declared | — | 12.9 ft · 3.93 m | — |
| Fuel tank declared | 42.3 qt · 40.0 L | 84.5 qt · 80.0 L | +100% 670 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann D-410 sources
- Source: Traktorenlexikon, “Hürlimann D 410”
- Source: Traktorenlexikon, “Hürlimann D 200 S”
- Source: Traktorenlexikon, “Hürlimann D 410 Synchromatic”
SOMECA 670 (DT) sources
- Source: Traktorenlexikon, “Someca 670”