5 material differences · fewer than 12
Tractor oneHürlimann D-180 (A)1973–1974No measured PTO figureTractor twoHürlimann H-480 (A)1979–1982No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1973–1974; 1979–1982). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | D-180 (A) | H-480 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 75.9 hp | 80.9 hp | +7% H-480 (A) |
| Engine declared | Hürlimann DS-210 | Hürlimann H-1104/7 | differs |
| Displacement declared | 4.43 L | 4.56 L | — |
| Maximum torque declared | — | 232 lb·ft · 315 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | — | Dry SAME double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 9.5 gpm · 36.0 L/min | 9.2 gpm · 34.8 L/min | — |
| Pressure declared | 2,774 psi · 191 bar | — | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,658 lb · 3,020 kg | 6,722 lb · 3,049 kg | — |
| Wheelbase declared | 90.9 in · 2,310 mm | 92.1 in · 2,340 mm | — |
| Length declared | 147.6 in · 3,750 mm | 156.7 in · 3,980 mm | +6% H-480 (A) |
| Width declared | 75.6 in · 1,920 mm | 76.8–104.3 in · 1,950–2,650 mm | differs |
| Ground clearance declared | 17.3 in · 440 mm | 15.7 in · 400 mm | +10% D-180 (A) |
| Fuel tank declared | — | 100.4 qt · 95.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann D-180 (A) sources
- Source: Traktorenlexikon, “Hürlimann D 180”
- Source: Traktorenlexikon, “Hürlimann D 210 (A)”
Hürlimann H-480 (A) sources
- Source: Traktorenlexikon, “Hürlimann H 480”