6 material differences · fewer than 12
Tractor oneHürlimann D-100 Allrad1966–1971No measured PTO figureTractor twoJohn Deere 1020 VU1967–1972No measured PTO figure
Which should you choose?
Read our verdict on the D-100 Allrad and the 1020 VU → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D-100 Allrad | 1020 VU | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 44.1 hp | 43.4 hp | — |
| Engine declared | Hürlimann D-70 DS | John Deere M 4 FL 4 or 3.164 DL-04 | differs |
| Displacement declared | 2.65 L | — | — |
| Maximum torque declared | 115 lb·ft · 156 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 12.4–15.5 mph · 20–25 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | — | 7.0 gpm · 26.6 L/min | — |
| Rear PTO speeds declared | 540/1050 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,401 lb · 2,450 kg | 3,715 lb · 1,685 kg | +45% D-100 Allrad |
| Maximum permissible mass declared | — | 7,055 lb · 3,200 kg | — |
| Wheelbase declared | — | 63.0 in · 1,600 mm | — |
| Length declared | 128.0 in · 3,250 mm | 122.0 in · 3,100 mm | — |
| Width declared | 68.5 in · 1,740 mm | 38.6 in · 980 mm | +78% D-100 Allrad |
| Ground clearance declared | — | 10.6 in · 270 mm | — |
| Turning radius, braked declared | — | 9.2 ft · 2.79 m | — |
| Fuel tank declared | 42.3 qt · 40.0 L | 47.6 qt · 45.0 L | +13% 1020 VU |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann D-100 Allrad sources
- Source: Traktorenlexikon, “Hürlimann D 100 A”
- Source: Traktorenlexikon, “Hürlimann D 70 SSP”
John Deere 1020 VU sources
- Source: Traktorenlexikon, “John Deere 1020 VU”
- Source: Traktorenlexikon, “John Deere 1020”