8 material differences · fewer than 12
Tractor oneHürlimann 77001976–1978No measured PTO figureTractor twoLandini 8800 (DT)1987–2000No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (30%); they were not built in overlapping years (1976–1978; 1987–2000). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 7700 | 8800 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 75.9 hp | 75.9 hp | — |
| Engine declared | Hürlimann D-310 | PERKINS LF 4.248 | differs |
| Displacement declared | 4.95 L | 4.07 L | +22% 7700 |
| Maximum torque declared | — | 185 lb·ft · 251 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 8800 (DT) |
| Clutch declared | — | Pedal-operated dry single-disc clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 13.6 gpm · 51.5 L/min | — |
| Three-point lift, at the coupling points declared | 5,313 lb · 2,410 kg | 7,397 lb · 3,355 kg | +39% 8800 (DT) |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,460 lb · 2,930 kg | 8,422 lb · 3,820 kg | +30% 8800 (DT) |
| Wheelbase declared | 93.7 in · 2,380 mm | 93.3 in · 2,371 mm | — |
| Length declared | 147.6 in · 3,750 mm | 155.9 in · 3,959 mm | +6% 8800 (DT) |
| Width declared | 75.6 in · 1,920 mm | 78.3 in · 1,990 mm | — |
| Ground clearance declared | — | 14.1 in · 357 mm | — |
| Fuel tank declared | 58.1 qt · 55.0 L | 156.4 qt · 148.0 L | +169% 8800 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hürlimann 7700 sources
- Source: Traktorenlexikon, “Hürlimann 7700”
Landini 8800 (DT) sources
- Source: Traktorenlexikon, “Landini 8800 DT”