5 material differences · fewer than 12

Tractor oneHermann Lanz D 301956–1960No measured PTO figureTractor twoMAN 2N11961–1962No measured PTO figure

Which should you choose?

Read our verdict on the D 30 and the 2N1 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

5 material differences · 7 fields identical or within 5%, which is not counted as material

Hermann Lanz D 30 and MAN 2N1, field by field
FieldD 302N1Gap
Engine
Engine power, claimed claimed27.5 hp27.5 hp—
Engine declaredHela AZ 1MAN D 9422 M 2differs
Displacement declared—1.66 L—
Transmission
Top speed declared12.3 mph · 19.8 km/h11.8 mph · 19 km/h—
Clutch declaredsingle-plate dry clutchSingle plate dry clutchdiffers
Hydraulics & hitch
Pump flow declared9.0 gpm · 34.0 L/min——
Rear PTO speeds declared572 rpm540/1000 rpmdiffers
Weight & dimensions
Unladen weight declared3,671 lb · 1,665 kg3,527 lb · 1,600 kg—
Wheelbase declared74.8 in · 1,900 mm73.5 in · 1,868 mm—
Length declared122.0 in · 3,100 mm122.4 in · 3,110 mm—
Width declared61.0 in · 1,550 mm62.2 in · 1,580 mm—
Ground clearance declared12.6 in · 320 mm15.7 in · 400 mm+25% 2N1
Turning radius, braked declared9.8 ft · 3.00 m9.5 ft · 2.90 m—
Fuel tank declared52.8 qt · 50 L44.4 qt · 42 L+19% D 30

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Hermann Lanz D 30 sources

Source
  • Source: Traktorenlexikon, “HELA D30”

MAN 2N1 sources

Source
  • Source: Traktorenlexikon, “MAN 2N1”
  • Source: Traktorenlexikon, “MAN 4N2”