5 material differences · fewer than 12
Tractor oneHermann Lanz D 260 A1971–1979No measured PTO figureTractor twoZETOR 6211/62451984–1993No measured PTO figure
Which should you choose?
Read our verdict on the D 260 A and the 6211/6245 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | D 260 A | 6211/6245 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 58.9 hp | 58.2 hp | — |
| Engine declared | MWM D 225-4 ( 7/1971 bis 3/1976 ) | ZBROJORKA Z-6201 | differs |
| Displacement declared | — | 3.46 L | — |
| Maximum torque declared | 166 lb·ft · 226 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.8 mph · 25.4 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | Double clutch by Fichtel & Sachs | Dry Zbrojovka double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 15.0 gpm · 56.9 L/min | — |
| Pressure declared | — | 1,160 psi · 80 bar | — |
| Rear PTO speeds declared | 552/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,658 lb · 3,020 kg | 6,526 lb · 2,960 kg | — |
| Maximum permissible mass declared | 9,700 lb · 4,400 kg | — | — |
| Wheelbase declared | 92.5 in · 2,350 mm | 88.9 in · 2,257 mm | — |
| Length declared | 141.7 in · 3,600 mm | 148.0 in · 3,760 mm | — |
| Width declared | 76.0 in · 1,930 mm | 72.4 in · 1,840 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 18.5 in · 470 mm | +18% 6211/6245 |
| Turning radius, braked declared | 18.0 ft · 5.50 m | 11.3 ft · 3.44 m | +60% D 260 A |
| Fuel tank declared | 74.0 qt · 70 L | 74.0 qt · 70.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hermann Lanz D 260 A sources
- Source: Traktorenlexikon, “HELA D 260 A”
ZETOR 6211/6245 sources
- Source: Traktorenlexikon, “Zetor 6211”