10 material differences · fewer than 12
Tractor oneHermann Lanz D 260 A1971–1979No measured PTO figureTractor twoWHITE 2-601976–1980No measured PTO figure
Which should you choose?
Read our verdict on the D 260 A and the 2-60 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D 260 A | 2-60 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 58.9 hp | 59.1 hp | — |
| Engine declared | MWM D 225-4 ( 7/1971 bis 3/1976 ) | FIAT-IVECO 8045.02.200 | differs |
| Displacement declared | — | 3.46 L | — |
| Maximum torque declared | 166 lb·ft · 226 N·m | 147 lb·ft · 199 N·m | +14% D 260 A |
| Transmission | |||
| Top speed declared | 15.8 mph · 25.4 km/h | 18.6 mph · 30 km/h | +18% 2-60 |
| Clutch declared | Double clutch by Fichtel & Sachs | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 5.8 gpm · 21.8 L/min | — |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 552/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,658 lb · 3,020 kg | 5,161 lb · 2,341 kg | +29% D 260 A |
| Maximum permissible mass declared | 9,700 lb · 4,400 kg | — | — |
| Wheelbase declared | 92.5 in · 2,350 mm | 81.3 in · 2,065 mm | +14% D 260 A |
| Length declared | 141.7 in · 3,600 mm | 126.0 in · 3,200 mm | +13% D 260 A |
| Width declared | 76.0 in · 1,930 mm | 72.8 in · 1,850 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 20.0 in · 508 mm | +27% 2-60 |
| Turning radius, braked declared | 18.0 ft · 5.50 m | 11.2 ft · 3.40 m | +62% D 260 A |
| Fuel tank declared | 74.0 qt · 70 L | 57.1 qt · 54.0 L | +30% D 260 A |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hermann Lanz D 260 A sources
- Source: Traktorenlexikon, “HELA D 260 A”
WHITE 2-60 sources
- Source: Traktorenlexikon, “White 2-60”
- Source: Traktorenlexikon, “Someca 600”