9 material differences · fewer than 12
Tractor oneHanomag Perfekt 401 (S)1964–1967No measured PTO figureTractor twoWHITE 2-351979–1984No measured PTO figure
Which should you choose?
Read our verdict on the Perfekt 401 (S) and the 2-35 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | Perfekt 401 (S) | 2-35 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 31 hp | 30.6 hp | — |
| Engine declared | Hanomag-Borgward D 301 R | ISUZU 3 AB-1 | differs |
| Displacement declared | 1.80 L | 1.78 L | — |
| Maximum torque declared | 73 lb·ft · 99 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 18.6 mph · 30 km/h | +50% 2-35 |
| Clutch declared | dual clutch by Fichtel & Sachs | Foot-operated two-stage dry single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 5.0 gpm · 19.0 L/min | 6.6 gpm · 25.0 L/min | +32% 2-35 |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,924 lb · 1,780 kg | 2,690 lb · 1,220 kg | +46% Perfekt 401 (S) |
| Wheelbase declared | 80.1 in · 2,035 mm | 69.0 in · 1,753 mm | +16% Perfekt 401 (S) |
| Length declared | 133.1 in · 3,380 mm | 122.0 in · 3,099 mm | +9% Perfekt 401 (S) |
| Width declared | 62.2 in · 1,580 mm | 61.0 in · 1,549 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 15.0 in · 381 mm | — |
| Turning radius, braked declared | 11.2 ft · 3.40 m | 9.0 ft · 2.75 m | +24% Perfekt 401 (S) |
| Fuel tank declared | 49.7 qt · 47 L | 31.7 qt · 30.0 L | +57% Perfekt 401 (S) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag Perfekt 401 (S) sources
- Source: Traktorenlexikon, “Hanomag Perfekt 401 (S)”
WHITE 2-35 sources
- Source: Traktorenlexikon, “White 2-35”