7 material differences · fewer than 12
Tractor oneHanomag Granit 501 E (S)1967–1970No measured PTO figureTractor twoHermann Lanz D 648 Allrad1973–1978No measured PTO figure
Which should you choose?
Read our verdict on the Granit 501 E (S) and the D 648 Allrad → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | Granit 501 E (S) | D 648 Allrad | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47 hp | 47.1 hp | — |
| Engine declared | — | MWM D 225-3 ( 10/1973 bis 12/1974 ) | — |
| Maximum torque declared | 109 lb·ft · 148 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4–16.9 mph · 20.0–27.2 km/h | 17.6 mph · 28.4 km/h | differs |
| Clutch declared | — | Maintenance-free dry single-plate clutch | — |
| Hydraulics & hitch | |||
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 595/980 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,762 lb · 2,160 kg | 5,291 lb · 2,400 kg | +11% D 648 Allrad |
| Maximum permissible mass declared | 7,606 lb · 3,450 kg | 9,921 lb · 4,500 kg | +30% D 648 Allrad |
| Wheelbase declared | 82.7 in · 2,100 mm | 84.3 in · 2,140 mm | — |
| Length declared | 134.6 in · 3,420 mm | 141.7 in · 3,600 mm | +5% D 648 Allrad |
| Width declared | 69.5 in · 1,765 mm | 66.9 in · 1,700 mm | — |
| Ground clearance declared | 15.4 in · 390 mm | 14.6 in · 370 mm | +5% Granit 501 E (S) |
| Turning radius, braked declared | 10.5 ft · 3.20 m | 14.3 ft · 4.35 m | +36% D 648 Allrad |
| Fuel tank declared | — | 74.0 qt · 70 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag Granit 501 E (S) sources
- Source: Traktorenlexikon, “Hanomag Granit 501 E (S)”
Hermann Lanz D 648 Allrad sources
- Source: Traktorenlexikon, “HELA D648A”