10 material differences · fewer than 12
Tractor oneHanomag C 2181957–1959No measured PTO figureTractor twoMASSEY-HARRIS Pony 8201957–1961No measured PTO figure
Which should you choose?
Read our verdict on the C 218 and the Pony 820 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | C 218 | Pony 820 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 17.7 hp | 18.0 hp | — |
| Engine declared | Hanomag D 621 | HANOMAG D 621-E 54 | differs |
| Displacement declared | 1.02 L | 1.02 L | — |
| Maximum torque declared | 58 lb·ft · 78 N·m | 58 lb·ft · 78 N·m | — |
| Transmission | |||
| Top speed declared | 11.5 mph · 18.5 km/h | 9.3 mph · 15 km/h | +23% C 218 |
| Clutch declared | Single-disc dry clutch from Fichtel & Sachs | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 3.7 gpm · 14.0 L/min | 2.5 gpm · 9.5 L/min | +47% C 218 |
| Rear PTO speeds declared | 1211 | 534 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,031 lb · 1,375 kg | 2,315 lb · 1,050 kg | +31% C 218 |
| Wheelbase declared | 77.2 in · 1,960 mm | 67.3 in · 1,710 mm | +15% C 218 |
| Length declared | 122.0 in · 3,100 mm | 110.2 in · 2,800 mm | +11% C 218 |
| Width declared | 63.0–73.2 in · 1,600–1,860 mm | 56.0–80.0 in · 1,422–2,032 mm | differs |
| Ground clearance declared | 15.7 in · 400 mm | 18.5 in · 470 mm | +18% Pony 820 |
| Turning radius, braked declared | 8.5 ft · 2.60 m | — | — |
| Fuel tank declared | 47.6 qt · 45 L | 27.5 qt · 26.0 L | +73% C 218 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Hanomag C 218 sources
- Source: Traktorenlexikon, “Hanomag C 218”
MASSEY-HARRIS Pony 820 sources
- Source: Traktorenlexikon, “Massey-Harris Massey-Harris Pony 820”