7 material differences · fewer than 12
Tractor oneGüldner G 60 (S)1968–1969No measured PTO figureTractor twoSOMECA 715 (DT)1966–1967No measured PTO figure
Which should you choose?
Read our verdict on the G 60 (S) and the 715 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | G 60 (S) | 715 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 59.3 hp | 59.3 hp | — |
| Engine declared | Güldner 6 L 79 | O.M.-FIAT CO-2 D/70 | differs |
| Displacement declared | 4.71 L | — | — |
| Maximum torque declared | 174 lb·ft · 236 N·m | 192 lb·ft · 260 N·m | +10% 715 (DT) |
| Transmission | |||
| Top speed declared | 16.3 mph · 26.22 km/h | 15.5 mph · 25 km/h | — |
| Clutch declared | — | Pedal-operated two-stage dry FERODO double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 7.0 gpm · 26.5 L/min | — |
| Pressure declared | 2,134 psi · 147 bar | 2,843 psi · 196 bar | +33% 715 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,063 lb · 2,750 kg | 6,349 lb · 2,880 kg | — |
| Maximum permissible mass declared | 9,700 lb · 4,400 kg | — | — |
| Wheelbase declared | 91.1 in · 2,315 mm | 86.6 in · 2,200 mm | — |
| Length declared | 155.7 in · 3,955 mm | 149.6 in · 3,800 mm | — |
| Width declared | 73.4 in · 1,865 mm | 70.9 in · 1,800 mm | — |
| Ground clearance declared | 15.7 in · 400 mm | 18.3 in · 465 mm | +16% 715 (DT) |
| Turning radius, braked declared | 11.7 ft · 3.58 m | 12.5 ft · 3.80 m | +6% 715 (DT) |
| Fuel tank declared | 68.7 qt · 65 L | 88.8 qt · 84.0 L | +29% 715 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Güldner G 60 (S) sources
- Source: Traktorenlexikon, “Güldner G 60”
- Source: Traktorenlexikon, “Güldner G 75”
SOMECA 715 (DT) sources
- Source: Traktorenlexikon, “Someca 715”
- Source: Traktorenlexikon, “Fiat 715/715 DT”