9 material differences · fewer than 12
Tractor oneGüldner G 30 (S)1963–1969No measured PTO figureTractor twoZickler 37541966–1967No measured PTO figure
Which should you choose?
Read our verdict on the G 30 (S) and the 3754 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
9 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | G 30 (S) | 3754 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 29.5 hp | 30 hp | — |
| Engine declared | Güldner 3 L 79 | — | — |
| Displacement declared | 2.36 L | — | — |
| Maximum torque declared | 95 lb·ft · 128 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4–18.6 mph · 20–30 km/h | 11.7 mph · 18.79 km/h | differs |
| Clutch declared | Pedal-operated, dry double clutch from Fichtel & Sachs | Single-plate dry clutch | differs |
| Hydraulics & hitch | |||
| Pressure declared | 2,134 psi · 147 bar | — | — |
| Rear PTO speeds declared | 540/1150 rpm | 588 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,112 lb · 1,865 kg | 2,315 lb · 1,050 kg | +78% G 30 (S) |
| Maximum permissible mass declared | 8,267 lb · 3,750 kg | 3,726 lb · 1,690 kg | +122% G 30 (S) |
| Wheelbase declared | 76.9 in · 1,954 mm | 54.3 in · 1,380 mm | +42% G 30 (S) |
| Length declared | 127.4 in · 3,235 mm | — | — |
| Width declared | 62.6 in · 1,590 mm | 36.2 in · 920 mm | +73% G 30 (S) |
| Ground clearance declared | 15.4 in · 390 mm | 9.1 in · 230 mm | +70% G 30 (S) |
| Turning radius, braked declared | 10.3 ft · 3.15 m | 6.4 ft · 1.95 m | +62% G 30 (S) |
| Fuel tank declared | 52.8 qt · 50 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Güldner G 30 (S) sources
- Source: Traktorenlexikon, “Güldner G 30”
- Source: Traktorenlexikon, “Güldner G 40 Toledo”
Zickler 3754 sources
- Source: Traktorenlexikon, “Zickler 3754”