10 material differences · fewer than 12
Tractor oneGüldner ADN1953–1959No measured PTO figureTractor twoWarchalowski WT 141956–1959No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (26%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | ADN | WT 14 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 15.7 hp | 13.8 hp | +14% ADN |
| Engine declared | Güldner 2 DN or 2 DNS | WARCHALOWSKI SD-21 or D-21 | differs |
| Displacement declared | 1.31 L | 1.02 L | +28% ADN |
| Transmission | |||
| Top speed declared | 11.8 mph · 19 km/h | 14.9–17.4 mph · 24–28 km/h | differs |
| Clutch declared | Pedal operated dry Fichtel & Sachs single-plate clutch | pedal-operated dry Fichtel & Sachs single-disc clutch | differs |
| Hydraulics & hitch | |||
| Pressure declared | 1,707 psi · 118 bar | — | — |
| Rear PTO speeds declared | 530 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 2,458 lb · 1,115 kg | 1,951 lb · 885 kg | +26% ADN |
| Maximum permissible mass declared | 3,417 lb · 1,550 kg | — | — |
| Wheelbase declared | 63.0–70.5 in · 1,600–1,790 mm | 66.5 in · 1,690 mm | differs |
| Length declared | 103.7–111.2 in · 2,635–2,825 mm | 97.6 in · 2,480 mm | differs |
| Width declared | 59.6 in · 1,514 mm | 60.8 in · 1,545 mm | — |
| Ground clearance declared | 19.7 in · 500 mm | 11.2 in · 285 mm | +75% ADN |
| Turning radius, braked declared | 9.5 ft · 2.90 m | 9.7 ft · 2.95 m | — |
| Fuel tank declared | 38.0 qt · 36 L | 19.0–22.2 qt · 18.0–21.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Güldner ADN sources
- Source: Traktorenlexikon, “Güldner ADN”
Warchalowski WT 14 sources
- Source: Traktorenlexikon, “Warchalowski WT 14”