8 material differences · fewer than 12
Tractor oneFord 95001968–1975No measured PTO figureTractor twoSOMECA 1000 (TD)1971–1977No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 9500 | 1000 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 94 hp | 93.7 hp | — |
| Engine declared | — | FIAT-IVECO 8065.02.007 | — |
| Displacement declared | — | 5.18 L | — |
| Maximum torque declared | 231 lb·ft · 314 N·m | 226 lb·ft · 306 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 15.5 mph · 25 km/h | +25% 1000 (TD) |
| Clutch declared | Single-plate dry clutch | Pedal operated two stage dry FERODO double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.0 gpm · 22.7 L/min | 12.3 gpm · 46.5 L/min | +105% 1000 (TD) |
| Pressure declared | 2,538 psi · 175 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,047 lb · 3,650 kg | 7,771 lb · 3,525 kg | — |
| Wheelbase declared | 105.9 in · 2,690 mm | 97.6 in · 2,480 mm | +8% 9500 |
| Length declared | 159.1 in · 4,040 mm | 164.2 in · 4,170 mm | — |
| Width declared | 76.8 in · 1,950 mm | 78.7–99.7 in · 1,998–2,532 mm | differs |
| Ground clearance declared | 19.7 in · 500 mm | 22.5 in · 571 mm | +14% 1000 (TD) |
| Turning radius, braked declared | 13.0 ft · 3.95 m | 12.5 ft · 3.81 m | — |
| Fuel tank declared | 79.9 qt · 75.6 L | 124.7 qt · 118.0 L | +56% 1000 (TD) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 9500 sources
- Source: Traktorenlexikon, “Ford 9500”
SOMECA 1000 (TD) sources
- Source: Traktorenlexikon, “Someca 1000”
- Source: Traktorenlexikon, “Fiat 1000/1000 DT”