5 material differences · fewer than 12

Tractor oneFord 8700 (A)1976–1979No measured PTO figureTractor twoFord TW-10 (A)1979–1983No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their power is identical, with the same weight or the same engine, which usually means one machine sold under two names; any difference below comes from how each source describes it. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

5 material differences · 10 fields identical or within 5%, which is not counted as material

Ford 8700 (A) and Ford TW-10 (A), field by field
Field8700 (A)TW-10 (A)Gap
Engine
Engine power, claimed claimed125.3 hp125.3 hp—
Engine declaredFord 401 DFFord 401 DF—
Displacement declared6.58 L6.58 L—
Maximum torque declared313 lb·ft · 424 N·m333 lb·ft · 452 N·m+7% TW-10 (A)
Transmission
Top speed declared15.5 mph · 25 km/h15.5–18.6 mph · 25–30 km/hdiffers
Clutch declaredpedal-operated dry single-plate clutchPedal operated dry single plate clutchdiffers
Hydraulics & hitch
Pump flow declared—15.9 gpm · 60.0 L/min—
Three-point lift, at the coupling points declared7,055 lb · 3,200 kg8,113 lb · 3,680 kg+15% TW-10 (A)
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared12,271 lb · 5,566 kg12,866 lb · 5,836 kg—
Wheelbase declared97.6 in · 2,480 mm109.7 in · 2,786 mm+12% TW-10 (A)
Length declared176.0 in · 4,470 mm176.0 in · 4,470 mm—
Width declared82.8 in · 2,102 mm86.6 in · 2,200 mm—
Ground clearance declared25.2 in · 640 mm25.2 in · 640 mm—
Turning radius, braked declared13.3 ft · 4.06 m13.2 ft · 4.01 m—
Fuel tank declared211.3 qt · 200.0 L211.3 qt · 200.0 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Ford 8700 (A) sources

Source
  • Source: Traktorenlexikon, “Ford 8700”
  • Source: Traktorenlexikon, “Ford 8600”

Ford TW-10 (A) sources

Source
  • Source: Traktorenlexikon, “Ford TW 10”
  • Source: Traktorenlexikon, “Ford 8600”