11 material differences · fewer than 12
Tractor oneFord 7840 (A)1991–1998No measured PTO figureTractor twoZETOR 10111/101451984–1990No measured PTO figure
Which should you choose?
Read our verdict on the 7840 (A) and the 10111/10145 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 7840 (A) | 10111/10145 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 98.6 hp | 98.6 hp | — |
| Engine declared | FORD-POWERSTAR GA 401 CID-NA | ZETOR Z-8002.1 | differs |
| Displacement declared | 6.58 L | 4.56 L | +44% 7840 (A) |
| Maximum torque declared | 279 lb·ft · 378 N·m | 227 lb·ft · 308 N·m | +23% 7840 (A) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | Pedal-operated, self-adjusting dry AP single-disc clutch | Pedal-operated dry ZTS single-disc clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 9.6 gpm · 36.4 L/min | 12.2 gpm · 46.2 L/min | +27% 10111/10145 |
| Pressure declared | 2,857 psi · 197 bar | 2,828 psi · 195 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,348 lb · 4,240 kg | 9,414 lb · 4,270 kg | — |
| Wheelbase declared | 105.9 in · 2,690 mm | 93.9 in · 2,385 mm | +13% 7840 (A) |
| Length declared | 171.7 in · 4,361 mm | 163.0 in · 4,140 mm | +5% 7840 (A) |
| Width declared | 82.5–101.6 in · 2,095–2,581 mm | 76.4–89.8 in · 1,940–2,280 mm | differs |
| Ground clearance declared | 18.0 in · 456 mm | 11.8 in · 300 mm | +52% 7840 (A) |
| Turning radius, braked declared | — | 11.9 ft · 3.63 m | — |
| Fuel tank declared | 240.0 qt · 227.1 L | 132.1 qt · 125.0 L | +82% 7840 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 7840 (A) sources
- Source: Traktorenlexikon, “Ford 7840”
ZETOR 10111/10145 sources
- Source: Traktorenlexikon, “Zetor 10111/10145”