11 material differences · fewer than 12
Tractor oneFord 7600 (A)1975–1981No measured PTO figureTractor twoSOMECA 940 (TD)1978–1979No measured PTO figure
Which should you choose?
Read our verdict on the 7600 (A) and the 940 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 7600 (A) | 940 (TD) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 90.8 hp | 90.8 hp | — |
| Engine declared | Ford 256 DF | O.M.-FIAT CO 3/80 | differs |
| Displacement declared | — | 4.94 L | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 15.5 mph · 25 km/h | +20% 7600 (A) |
| Clutch declared | Pedal operated dry Borg & Beck single disc clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 9.6 gpm · 36.4 L/min | — | — |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Three-point lift, at the coupling points declared | 5,952 lb · 2,700 kg | 8,378 lb · 3,800 kg | +41% 940 (TD) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,109 lb · 2,771 kg | 8,708 lb · 3,950 kg | +43% 940 (TD) |
| Wheelbase declared | 87.5 in · 2,223 mm | 93.3 in · 2,370 mm | +7% 940 (TD) |
| Length declared | 145.2 in · 3,689 mm | 159.4 in · 4,050 mm | +10% 940 (TD) |
| Width declared | 80.7–101.7 in · 2,051–2,584 mm | 76.2–99.7 in · 1,935–2,532 mm | differs |
| Ground clearance declared | 15.7 in · 400 mm | 22.4 in · 570 mm | +43% 940 (TD) |
| Turning radius, braked declared | 10.6 ft · 3.23 m | 12.6 ft · 3.84 m | +19% 940 (TD) |
| Fuel tank declared | 79.8 qt · 75.5 L | 95.1 qt · 90.0 L | +19% 940 (TD) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 7600 (A) sources
- Source: Traktorenlexikon, “Ford 7600”
- Source: Traktorenlexikon, “Ford 6600”
SOMECA 940 (TD) sources
- Source: Traktorenlexikon, “Someca 940”