Ford 7400 or Steyr 1100 (a)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 7400 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 1100 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Steyr 1100 (a) suits loader and hydraulic implement work better on this data: 56% (12.8 L/min / 3.4 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Ford 7400 and Steyr 1100 (a), with the call on each
Question74001100 (a)Call
Which puts more power through the PTO shaft?73.5 kW (98.6 hp)Traktorenlexikon, “Ford 7400”72.1 kW (96.7 hp)Traktorenlexikon, “Steyr 1100”Not comparableNot comparable on power at the PTO shaft: the 7400 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 1100 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 7400 and the 1100 (a).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 7400 and the 1100 (a).
Which pumps more oil for implements?22.7 L/min (6.0 gpm)Traktorenlexikon, “Ford 7400”35.5 L/min (9.4 gpm)Traktorenlexikon, “Steyr 1100”AheadThe Steyr 1100 (a) has 56% more hydraulic flow (12.8 L/min / 3.4 gpm) than the Ford 7400 (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?2,800 kg (6,173 lb)Traktorenlexikon, “Steyr 1100”No figureNo call on three-point lift: no figure on record for the 7400.
Which is heavier, for traction?3,750 kg (8,267 lb)Traktorenlexikon, “Ford 7400”3,340 kg (7,363 lb)Traktorenlexikon, “Steyr 1100”Ahead (a fact, not an advantage)The Ford 7400 is 12% heavier (410 kg / 904 lb) than the Steyr 1100 (a) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 7400 and the 1100 (a).
Which has the wider choice of gears?14Traktorenlexikon, “Ford 7400”12 to 16Traktorenlexikon, “Steyr 1100”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 7400 and the 1100 (a).
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Ford 7400”25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Steyr 1100”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Ford 7400”540/1000 rpmTraktorenlexikon, “Steyr 1100”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Ford 7400”independentTraktorenlexikon, “Steyr 1100”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?2WDTraktorenlexikon, “Ford 7400”2WD / 4WDTraktorenlexikon, “Steyr 1100”AheadThe Steyr 1100 (a) is available with four-wheel drive; the Ford 7400 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1970–19751971–1977EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Steyr 1100 (a) has 56% more hydraulic flow (12.8 L/min / 3.4 gpm) than the Ford 7400 (both pump flow, as stated by the source).
  • The Ford 7400 is 12% heavier (410 kg / 904 lb) than the Steyr 1100 (a) (both unladen weight, as stated by the source).
  • The Steyr 1100 (a) is available with four-wheel drive; the Ford 7400 is two-wheel drive (as stated by the sources).
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on PTO independence: every PTO is independent.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 7400 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 1100 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources