11 material differences · fewer than 12

Tractor oneFord 741/771 Workmaster1958–1962No measured PTO figureTractor twoSAME Delfino 32 (DT)1970–1971No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (31%); the drive differs (2WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1958–1962; 1970–1971). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

11 material differences · 1 fields identical or within 5%, which is not counted as material

Ford 741/771 Workmaster and SAME Delfino 32 (DT), field by field
Field741/771 WorkmasterDelfino 32 (DT)Gap
Engine
Engine power, claimed claimed42.1 hp29.6 hp+42% 741/771 Workmaster
Engine declared—SAME DA 027-952 L—
Displacement declared—1.70 L—
Maximum torque declared121 lb·ft · 164 N·m76 lb·ft · 103 N·m+59% 741/771 Workmaster
Transmission
Top speed declared17.4 mph · 28 km/h15.5 mph · 25 km/h+12% 741/771 Workmaster
Clutch declared—Pedal operated dry two stage SAME double clutch—
Hydraulics & hitch
Pump flow declared4.0 gpm · 15.0 L/min3.0 gpm · 11.2 L/min+34% 741/771 Workmaster
Three-point lift, at the coupling points declared1,250 lb · 567 kg2,436 lb · 1,105 kg+95% Delfino 32 (DT)
Rear PTO speeds declared540 rpm540 rpm—
Weight & dimensions
Unladen weight declared3,400 lb · 1,542 kg2,601 lb · 1,180 kg+31% 741/771 Workmaster
Wheelbase declared85.3 in · 2,167 mm67.7 in · 1,720 mm+26% 741/771 Workmaster
Length declared132.0 in · 3,353 mm103.5 in · 2,630 mm+27% 741/771 Workmaster
Width declared71.7 in · 1,821 mm58.3–79.5 in · 1,480–2,020 mmdiffers
Ground clearance declared27.5 in · 698 mm11.8 in · 300 mm+133% 741/771 Workmaster
Turning radius, braked declared9.2 ft · 2.81 m8.7 ft · 2.65 m+6% 741/771 Workmaster
Fuel tank declared62.3 qt · 59.0 L31.7 qt · 30.0 L+97% 741/771 Workmaster

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Ford 741/771 Workmaster sources

Source
  • Source: Traktorenlexikon, “Ford 701”

SAME Delfino 32 (DT) sources

Source
  • Source: Traktorenlexikon, “SAME Delfino 32”