11 material differences · fewer than 12
Tractor oneFord 6811958–1962No measured PTO figureTractor twoSAME Delfino 32 (DT)1970–1971No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (26%); the drive differs (2WD; Two-wheel or four-wheel drive); they were not built in overlapping years (1958–1962; 1970–1971). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
11 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 681 | Delfino 32 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 42.1 hp | 29.6 hp | +42% 681 |
| Engine declared | — | SAME DA 027-952 L | — |
| Displacement declared | — | 1.70 L | — |
| Maximum torque declared | 121 lb·ft · 164 N·m | 76 lb·ft · 103 N·m | +59% 681 |
| Transmission | |||
| Top speed declared | 17.4 mph · 28 km/h | 15.5 mph · 25 km/h | +12% 681 |
| Clutch declared | — | Pedal operated dry two stage SAME double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 4.0 gpm · 15.0 L/min | 3.0 gpm · 11.2 L/min | +34% 681 |
| Three-point lift, at the coupling points declared | 1,250 lb · 567 kg | 2,436 lb · 1,105 kg | +95% Delfino 32 (DT) |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,289 lb · 1,492 kg | 2,601 lb · 1,180 kg | +26% 681 |
| Wheelbase declared | 74.5 in · 1,892 mm | 67.7 in · 1,720 mm | +10% 681 |
| Length declared | 120.8 in · 3,069 mm | 103.5 in · 2,630 mm | +17% 681 |
| Width declared | 63.9–87.5 in · 1,623–2,223 mm | 58.3–79.5 in · 1,480–2,020 mm | differs |
| Ground clearance declared | 21.0 in · 533 mm | 11.8 in · 300 mm | +78% 681 |
| Turning radius, braked declared | 8.9 ft · 2.72 m | 8.7 ft · 2.65 m | — |
| Fuel tank declared | 62.3 qt · 59.0 L | 31.7 qt · 30.0 L | +97% 681 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 681 sources
- Source: Traktorenlexikon, “Ford 601”
SAME Delfino 32 (DT) sources
- Source: Traktorenlexikon, “SAME Delfino 32”