6 material differences · fewer than 12

Tractor oneFord 6401954–1957No measured PTO figureTractor twoJ.I. Case Modell-D1939–1953No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (132%); they were not built in overlapping years (1954–1957; 1939–1953). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

6 material differences · 3 fields identical or within 5%, which is not counted as material

Ford 640 and J.I. Case Modell-D, field by field
Field640Modell-DGap
Engine
Engine power, claimed claimed31.9 hp31.6 hp—
Transmission
Top speed declared12.4 mph · 20 km/h11.0 mph · 17.7 km/h+13% 640
Clutch declared—Hand lever operated double disc clutch—
Hydraulics & hitch
Pump flow declared2.7–6.0 gpm · 10.2–22.7 L/min——
Rear PTO speeds declared540 rpm540 rpm—
Weight & dimensions
Unladen weight declared3,018 lb · 1,369 kg7,004 lb · 3,177 kg+132% Modell-D
Wheelbase declared74.5 in · 1,892 mm66.4 in · 1,686 mm+12% 640
Length declared120.8 in · 3,069 mm116.0 in · 2,946 mm—
Width declared63.9–87.5 in · 1,623–2,223 mm61.5 in · 1,562 mmdiffers
Ground clearance declared21.0 in · 533 mm14.0 in · 356 mm+50% 640
Turning radius, braked declared18.0 ft · 5.49 m——
Fuel tank declared52.8 qt · 50.0 L67.9 qt · 64.3 L+29% Modell-D

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Ford 640 sources

Source
  • Source: Traktorenlexikon, “Ford 600”

J.I. Case Modell-D sources

Source
  • Source: Traktorenlexikon, “Case D”