7 material differences · fewer than 12
Tractor oneFord 6.500 (A)1968–1974No measured PTO figureTractor twoFord 95001968–1975No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 2WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 6.500 (A) | 9500 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 93.7 hp | 94 hp | — |
| Engine declared | Ford 2703 E | — | — |
| Displacement declared | 5.41 L | — | — |
| Maximum torque declared | 223 lb·ft · 303 N·m | 231 lb·ft · 314 N·m | — |
| Transmission | |||
| Top speed declared | 16.8 mph · 27 km/h | 12.4 mph · 20 km/h | +35% 6.500 (A) |
| Clutch declared | — | Single-plate dry clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 6.0 gpm · 22.7 L/min | — |
| Pressure declared | — | 2,538 psi · 175 bar | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,826 lb · 3,550 kg | 8,047 lb · 3,650 kg | — |
| Wheelbase declared | 100.4 in · 2,550 mm | 105.9 in · 2,690 mm | +5% 9500 |
| Length declared | 178.0 in · 4,520 mm | 159.1 in · 4,040 mm | +12% 6.500 (A) |
| Width declared | 79.9 in · 2,030 mm | 76.8 in · 1,950 mm | — |
| Ground clearance declared | 21.3 in · 540 mm | 19.7 in · 500 mm | +8% 6.500 (A) |
| Turning radius, braked declared | 14.1 ft · 4.30 m | 13.0 ft · 3.95 m | +9% 6.500 (A) |
| Fuel tank declared | 108.8 qt · 103.0 L | 79.9 qt · 75.6 L | +36% 6.500 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 6.500 (A) sources
- Source: Traktorenlexikon, “Ford 6500”
- Source: Traktorenlexikon, “Ford County Super 6/954”
Ford 9500 sources
- Source: Traktorenlexikon, “Ford 9500”