Ford 5640 (A) or Landini 8830 (DT) TL-23 N/E (TL-23 DT/F)?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Ford 5640 (A) and Landini 8830 (DT) TL-23 N/E (TL-23 DT/F), with the call on each
Question5640 (A)8830 (DT) TL-23 N/E (TL-23 DT/F)Call
Which puts more power through the PTO shaft?50.1 kW (67.2 hp)Traktorenlexikon, “Ford 5640”50.4 kW (67.6 hp)Traktorenlexikon, “Landini 8830 (DT)”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 5640 (A) and the 8830 (DT) TL-23 N/E (TL-23 DT/F).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 5640 (A) and the 8830 (DT) TL-23 N/E (TL-23 DT/F).
Which pumps more oil for implements?34.0 L/min (9.0 gpm)Traktorenlexikon, “Ford 5640”35.3 L/min (9.3 gpm)Traktorenlexikon, “Landini 8830 (DT)”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?2,880 kg (6,349 lb)Traktorenlexikon, “Ford 5640”3,000 kg (6,614 lb)Traktorenlexikon, “Landini 8830 (DT)”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?3,687 kg (8,128 lb)Traktorenlexikon, “Ford 5640”2,820 kg (6,217 lb)Traktorenlexikon, “Landini 8830 (DT)”Ahead (a fact, not an advantage)The Ford 5640 (A) is 31% heavier (867 kg / 1,911 lb) than the Landini 8830 (DT) TL-23 N/E (TL-23 DT/F) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 5640 (A) and the 8830 (DT) TL-23 N/E (TL-23 DT/F).
Which has the wider choice of gears?12 to 16Traktorenlexikon, “Ford 5640”12Traktorenlexikon, “Landini 8830 (DT)”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 5640 (A) and the 8830 (DT) TL-23 N/E (TL-23 DT/F).
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Ford 5640”30 km/h (18.6 mph)Traktorenlexikon, “Landini 8830 (DT)”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Ford 5640”540/1000 rpmTraktorenlexikon, “Landini 8830 (DT)”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Ford 5640”No figureNo call on PTO independence: not stated for the 8830 (DT) TL-23 N/E (TL-23 DT/F).
Which drives on both axles?2WD / 4WDTraktorenlexikon, “Ford 5640”Two-wheel or four-wheel driveTraktorenlexikon, “Landini 8830 (DT)”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1991–19971983–1987Ahead (a fact, not an advantage)The Ford 5640 (A) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Ford 5640 (A) is 31% heavier (867 kg / 1,911 lb) than the Landini 8830 (DT) TL-23 N/E (TL-23 DT/F) (both unladen weight, as stated by the source).
  • The Ford 5640 (A) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources