Ford 5600 (A) or Hürlimann H-466 (A)?

Which should you choose?

On performance, no comparable figure differs by more than its threshold: on this data the machines are level.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Ford 5600 (A) and Hürlimann H-466 (A), with the call on each
Question5600 (A)H-466 (A)Call
Which puts more power through the PTO shaft?42.5 kW (57.0 hp)Traktorenlexikon, “Ford 5600”42.4 kW (56.8 hp)Traktorenlexikon, “Hürlimann H 466”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 5600 (A) and the H-466 (A).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 5600 (A) and the H-466 (A).
Which pumps more oil for implements?36.6 L/min (9.7 gpm)Traktorenlexikon, “Ford 5600”No figureNo call on hydraulic flow: no figure on record for the H-466 (A).
Which lifts more on the three-point hitch?1,876 kg (4,136 lb)Traktorenlexikon, “Ford 5600”2,294 kg (5,058 lb)Traktorenlexikon, “Hürlimann H 466”Not comparableNot comparable on three-point lift: the 5600 (A): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Ford 5600”); the H-466 (A): lift through the full range at the hitch ends, as stated by the source (Traktorenlexikon, “Hürlimann H 466”) — not the same quantity, basis and condition.
Which is heavier, for traction?3,250 kg (7,165 lb)Traktorenlexikon, “Ford 5600”2,840 kg (6,261 lb)Traktorenlexikon, “Hürlimann H 466”Ahead (a fact, not an advantage)The Ford 5600 (A) is 14% heavier (410 kg / 904 lb) than the Hürlimann H-466 (A) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 5600 (A) and the H-466 (A).
Which has the wider choice of gears?8 to 16Traktorenlexikon, “Ford 5600”15 to 24Traktorenlexikon, “Hürlimann H 466”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 5600 (A) and the H-466 (A).
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Ford 5600”30 km/h (18.6 mph)Traktorenlexikon, “Hürlimann H 466”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Ford 5600”540/1000 rpmTraktorenlexikon, “Hürlimann H 466”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Ford 5600”No figureNo call on PTO independence: not stated for the H-466 (A).
Which drives on both axles?2WD / 4WDTraktorenlexikon, “Ford 5600”2WD / 4WDTraktorenlexikon, “Hürlimann H 466”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1975–19811983–1986Ahead (a fact, not an advantage)The Hürlimann H-466 (A) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Ford 5600 (A) is 14% heavier (410 kg / 904 lb) than the Hürlimann H-466 (A) (both unladen weight, as stated by the source).
  • The Hürlimann H-466 (A) is newer: production began 8 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on three-point lift: the 5600 (A): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Ford 5600”); the H-466 (A): lift through the full range at the hitch ends, as stated by the source (Traktorenlexikon, “Hürlimann H 466”) — not the same quantity, basis and condition.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources