Ford 4830 (A) or Landini R-6860 (DT) TL-21 N/K (TL-21 DT/K)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 4830 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the R-6860 (DT) TL-21 N/K (TL-21 DT/K) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 4830 (A) | R-6860 (DT) TL-21 N/K (TL-21 DT/K) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 47.8 kW (64.1 hp)Traktorenlexikon, “Ford 4830” | 47.8 kW (64.1 hp)Traktorenlexikon, “Landini 6860” | Not comparableNot comparable on power at the PTO shaft: the 4830 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the R-6860 (DT) TL-21 N/K (TL-21 DT/K) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 4830 (A) and the R-6860 (DT) TL-21 N/K (TL-21 DT/K). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 4830 (A) and the R-6860 (DT) TL-21 N/K (TL-21 DT/K). |
| Which pumps more oil for implements? | 35.3 L/min (9.3 gpm)Traktorenlexikon, “Ford 4830” | 38.4 L/min (10.1 gpm)Traktorenlexikon, “Landini 6860” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 1,987 kg (4,381 lb)Traktorenlexikon, “Ford 4830” | 1,867 kg (4,116 lb)Traktorenlexikon, “Landini 6860” | EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which is heavier, for traction? | 2,960 kg (6,526 lb)Traktorenlexikon, “Ford 4830” | 2,490 kg (5,490 lb)Traktorenlexikon, “Landini 6860” | Ahead (a fact, not an advantage)The Ford 4830 (A) is 19% heavier (470 kg / 1,036 lb) than the Landini R-6860 (DT) TL-21 N/K (TL-21 DT/K) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 4830 (A) and the R-6860 (DT) TL-21 N/K (TL-21 DT/K). |
| Which has the wider choice of gears? | 8 to 16Traktorenlexikon, “Ford 4830” | 12 to 24Traktorenlexikon, “Landini 6860” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 4830 (A) and the R-6860 (DT) TL-21 N/K (TL-21 DT/K). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Ford 4830” | 30 km/h (18.6 mph)Traktorenlexikon, “Landini 6860” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Ford 4830” | 540/1000 rpmTraktorenlexikon, “Landini 6860” | AheadThe Landini R-6860 (DT) TL-21 N/K (TL-21 DT/K) offers 1000 rpm at the PTO, which the Ford 4830 (A) does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “Ford 4830” | independentTraktorenlexikon, “Landini 6860” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Ford 4830” | Two-wheel or four-wheel driveTraktorenlexikon, “Landini 6860” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1990–1992 | 1988–2000 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Ford 4830 (A) is 19% heavier (470 kg / 1,036 lb) than the Landini R-6860 (DT) TL-21 N/K (TL-21 DT/K) (both unladen weight, as stated by the source).
- The Landini R-6860 (DT) TL-21 N/K (TL-21 DT/K) offers 1000 rpm at the PTO, which the Ford 4830 (A) does not (as stated by the sources).
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- Not comparable on power at the PTO shaft: the 4830 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the R-6860 (DT) TL-21 N/K (TL-21 DT/K) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources