14 material differences

Tractor oneFord 4130 (A)1990–1996No measured PTO figureTractor twoJohn Deere 1846 FA1996–2003No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (36%); the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

14 material differences · 2 fields identical or within 5%, which is not counted as material

Ford 4130 (A) and John Deere 1846 FA, field by field
Field4130 (A)1846 FAGap
Engine
Engine power, claimed claimed55.3 hp55.3 hp—
Engine declaredFord K 201 CID-NAJohn Deere 3029 DFG-22differs
Displacement declared3.29 L2.94 L+12% 4130 (A)
Maximum torque declared143 lb·ft · 194 N·m133 lb·ft · 181 N·m+7% 4130 (A)
Transmission
Top speed declared18.6–24.9 mph · 30–40 km/h24.9 mph · 40 km/hdiffers
Clutch declaredPedal operated dry AP single-disc clutchPedal-operated dry LuK double clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Hydraulic control declared—Load sensing—
Pump flow declared9.3 gpm · 35.3 L/min6.9 gpm · 26.0 L/min+36% 4130 (A)
Pressure declared1,378–1,450 psi · 95–100 bar2,176 psi · 150 bardiffers
Three-point lift, at the coupling points declared4,381 lb · 1,987 kg3,461 lb · 1,570 kg+27% 4130 (A)
Rear PTO speeds declared540 rpm540 rpm / 750 rpm / 1000 rpmdiffers
Weight & dimensions
Unladen weight declared6,155 lb · 2,792 kg4,519 lb · 2,050 kg+36% 4130 (A)
Wheelbase declared84.5 in · 2,146 mm75.3 in · 1,912 mm+12% 4130 (A)
Length declared138.6 in · 3,521 mm128.6 in · 3,267 mm+8% 4130 (A)
Width declared69.7–96.7 in · 1,771–2,457 mm57.5 in · 1,460 mmdiffers
Ground clearance declared13.9 in · 353 mm14.4 in · 365 mm—
Fuel tank declared69.4 qt · 65.7 L42.3 qt · 40.0 L+64% 4130 (A)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

Ford 4130 (A) sources

Source
  • Source: Traktorenlexikon, “Ford 4130”

John Deere 1846 FA sources

Source
  • Source: Traktorenlexikon, “John Deere 1846 F/A”