6 material differences · fewer than 12
Tractor oneFord 3000 "V" ( Dexta )1964–1975No measured PTO figureTractor twoJohn Deere 10201965–1975No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (57%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 3000 "V" ( Dexta ) | 1020 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 43 hp | 43.4 hp | — |
| Engine declared | — | John Deere M 4 FL 4 or 3.164 DL-04 | — |
| Maximum torque declared | 129 lb·ft · 175 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4–18.6 mph · 20–30 km/h | 12.4–15.5 mph · 20–25 km/h | differs |
| Clutch declared | — | Pedal operated two stage and dry Fichtel & Sachs double clutch | — |
| Hydraulics & hitch | |||
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 540 rpm / 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,148–6,393 lb · 1,428–2,900 kg | 4,938 lb · 2,240 kg | differs |
| Maximum permissible mass declared | — | 7,716 lb · 3,500 kg | — |
| Wheelbase declared | 80.0 in · 2,032 mm | 80.7 in · 2,050 mm | — |
| Length declared | 122.0 in · 3,100 mm | 135.0 in · 3,430 mm | +11% 1020 |
| Width declared | 44.5 in · 1,130 mm | 63.0–86.6 in · 1,600–2,200 mm | differs |
| Ground clearance declared | 15.6 in · 395 mm | 20.5 in · 521 mm | +32% 1020 |
| Turning radius, braked declared | — | 9.4 ft · 2.85 m | — |
| Fuel tank declared | 52.0 qt · 49.2 L | 66.0 qt · 62.5 L | +27% 1020 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 3000 "V" ( Dexta ) sources
- Source: Traktorenlexikon, “Ford 3000 V”
John Deere 1020 sources
- Source: Traktorenlexikon, “John Deere 1020”