Ford 2600 or Warchalowski WT-42 A?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 2600 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the WT-42 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Warchalowski WT-42A suits loader and hydraulic implement work better on this data: 42% (530 kg / 1,168 lb) more three-point lift.
  • The Warchalowski WT-42A suits heavy draft work (ploughing, cultivating) better on this data: four-wheel drive.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Ford 2600 and Warchalowski WT-42 A, with the call on each
Question2600WT-42 ACall
Which puts more power through the PTO shaft?27.9 kW (37.4 hp)Traktorenlexikon, “Ford 2600”27.9 kW (37.4 hp)Traktorenlexikon, “Warchalowski WT 42”Not comparableNot comparable on power at the PTO shaft: the 2600 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the WT-42 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the 2600 and the WT-42 A.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the 2600 and the WT-42 A.
Which pumps more oil for implements?31.4 L/min (8.3 gpm)Traktorenlexikon, “Ford 2600”—No figureNo call on hydraulic flow: no figure on record for the WT-42 A.
Which lifts more on the three-point hitch?1,270 kg (2,800 lb)Traktorenlexikon, “Ford 2600”1,800 kg (3,968 lb)Traktorenlexikon, “Warchalowski WT 42”AheadThe Warchalowski WT-42A has 42% more lift (530 kg / 1,168 lb) than the Ford 2600 (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?1,731 kg (3,816 lb)Traktorenlexikon, “Ford 2600”1,766 kg (3,893 lb)Traktorenlexikon, “Warchalowski WT 42”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the 2600 and the WT-42 A.
Which has the wider choice of gears?8Traktorenlexikon, “Ford 2600”8Traktorenlexikon, “Warchalowski WT 42”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?——No figureNo call on a creeper range: not stated for the 2600 and the WT-42 A.
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Ford 2600”29 km/h (18.0 mph)Traktorenlexikon, “Warchalowski WT 42”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Ford 2600”540 rpmTraktorenlexikon, “Warchalowski WT 42”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?——No figureNo call on PTO independence: not stated for the 2600 and the WT-42 A.
Which drives on both axles?2WDTraktorenlexikon, “Ford 2600”4WDTraktorenlexikon, “Warchalowski WT 42”AheadThe Warchalowski WT-42A is available with four-wheel drive; the Ford 2600 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1975–19811964–1969Ahead (a fact, not an advantage)The Ford 2600 is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Warchalowski WT-42A has 42% more lift (530 kg / 1,168 lb) than the Ford 2600 (both lift at the hitch ends, as stated by the source).
  • The Warchalowski WT-42A is available with four-wheel drive; the Ford 2600 is two-wheel drive (as stated by the sources).
  • The Ford 2600 is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Not comparable on power at the PTO shaft: the 2600 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the WT-42 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources