5 material differences · fewer than 12
Tractor oneFord 2000 "V" (Dexta)1964–1975No measured PTO figureTractor twoSOMECA 400 (DT)1968–1971No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (27%); the drive differs (2WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
5 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 2000 "V" (Dexta) | 400 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34 hp | 34 hp | — |
| Engine declared | — | O.M.-FIAT 8035.01.201 | — |
| Displacement declared | — | 2.34 L | — |
| Maximum torque declared | 100 lb·ft · 135 N·m | 103 lb·ft · 140 N·m | — |
| Transmission | |||
| Top speed declared | 12.4–15.5 mph · 20–25 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | dual dry clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 5.8 gpm · 21.8 L/min | — |
| Pressure declared | — | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,950–6,393 lb · 1,338–2,900 kg | 3,748 lb · 1,700 kg | differs |
| Wheelbase declared | 80.0 in · 2,032 mm | 75.6 in · 1,920 mm | +6% 2000 "V" (Dexta) |
| Length declared | 122.0 in · 3,100 mm | 126.0 in · 3,200 mm | — |
| Width declared | 41.5 in · 1,054 mm | 62.4–88.2 in · 1,585–2,240 mm | differs |
| Ground clearance declared | 15.6–16.9 in · 395–430 mm | 14.6 in · 370 mm | differs |
| Turning radius, braked declared | — | 9.7 ft · 2.95 m | — |
| Fuel tank declared | — | 57.1 qt · 54.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 2000 "V" (Dexta) sources
- Source: Traktorenlexikon, “Ford 2000 V”
SOMECA 400 (DT) sources
- Source: Traktorenlexikon, “Someca 400”