8 material differences · fewer than 12
Tractor oneFord 2000 "V" (Dexta)1964–1975No measured PTO figureTractor twoSAME Delfino 35 (DT)1972–1981No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 2000 "V" (Dexta) | Delfino 35 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 34 hp | 34 hp | — |
| Engine declared | — | SAME DA 034-982 L | — |
| Displacement declared | — | 1.81 L | — |
| Maximum torque declared | 100 lb·ft · 135 N·m | 90 lb·ft · 122 N·m | +11% 2000 "V" (Dexta) |
| Transmission | |||
| Top speed declared | 12.4–15.5 mph · 20–25 km/h | 15.5 mph · 25 km/h | differs |
| Clutch declared | dual dry clutch | Pedal operated dry two stage SAME double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 3.4 gpm · 13.0 L/min | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 2,950–6,393 lb · 1,338–2,900 kg | 3,086 lb · 1,400 kg | differs |
| Wheelbase declared | 80.0 in · 2,032 mm | 66.9 in · 1,700 mm | +20% 2000 "V" (Dexta) |
| Length declared | 122.0 in · 3,100 mm | 107.1 in · 2,720 mm | +14% 2000 "V" (Dexta) |
| Width declared | 41.5 in · 1,054 mm | 59.4–87.0 in · 1,510–2,210 mm | differs |
| Ground clearance declared | 15.6–16.9 in · 395–430 mm | 15.0 in · 380 mm | differs |
| Turning radius, braked declared | — | 8.7 ft · 2.65 m | — |
| Fuel tank declared | — | 26.4 qt · 25.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Ford 2000 "V" (Dexta) sources
- Source: Traktorenlexikon, “Ford 2000 V”
SAME Delfino 35 (DT) sources
- Source: Traktorenlexikon, “SAME Delfino 35”