Ford 2000 Dexta (A) vs International Harvester D-440
6 material differences · fewer than 12
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD / 4WD; 2WD); they were not built in overlapping years (1968–1975; 1958–1959). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 2000 Dexta (A) | D-440 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 39.3 hp | 39.4 hp | — |
| Engine declared | — | INTERNATIONAL-HARVESTER DD-132 S | — |
| Displacement declared | — | 2.18 L | — |
| Maximum torque declared | 112 lb·ft · 152 N·m | 112 lb·ft · 152 N·m | — |
| Transmission | |||
| Top speed declared | 12.4–18.6 mph · 20–30 km/h | 12.4 mph · 20 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 6.3 gpm · 24.0 L/min | — |
| Pressure declared | — | 2,119 psi · 146 bar | — |
| Three-point lift at ends declared | — | 4,409 lb · 2,000 kg | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,123 lb · 1,870 kg | 4,277 lb · 1,940 kg | — |
| Maximum permissible mass declared | — | 7,033 lb · 3,190 kg | — |
| Wheelbase declared | 76.0 in · 1,930 mm | 74.0 in · 1,880 mm | — |
| Length declared | 126.4 in · 3,210 mm | 118.5 in · 3,010 mm | +7% 2000 Dexta (A) |
| Width declared | 63.8 in · 1,620 mm | 73.4 in · 1,865 mm | +15% D-440 |
| Height declared | 89.8 in · 2,280 mm | 62.3 in · 1,583 mm | +44% 2000 Dexta (A) |
| Ground clearance declared | 19.7 in · 500 mm | 16.8 in · 427 mm | +17% 2000 Dexta (A) |
| Turning radius, braked declared | 9.8 ft · 3.00 m | 9.8 ft · 3.00 m | — |
| Fuel tank declared | 51.8 qt · 49 L | 58.1 qt · 55.0 L | +12% D-440 |
Ford 2000 Dexta (A) sources
Source
- Source: Traktorenlexikon, “Ford 2000 S”
International Harvester D-440 sources
Source
- Source: Traktorenlexikon, “McCormick D-440 Standard”