Ford 1700 (A) or International Harvester 323?

Which should you choose?

On performance, every comparable figure that differs favours the Ford 1700 (A): hydraulic flow. It is also ahead on drive.

  • The Ford 1700 (A) suits loader and hydraulic implement work better on this data: 18% (4.5 L/min / 1.2 gpm) more hydraulic flow.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Ford 1700 (A) and International Harvester 323, with the call on each
Question1700 (A)323Call
Which puts more power through the PTO shaft?17.2 kW (23.1 hp)Traktorenlexikon, “Ford 1700”17.5 kW (23.5 hp)Traktorenlexikon, “McCormick 323”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 1700 (A) and the 323.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 1700 (A) and the 323.
Which pumps more oil for implements?29.5 L/min (7.8 gpm)Traktorenlexikon, “Ford 1700”25.0 L/min (6.6 gpm)Traktorenlexikon, “McCormick 323”AheadThe Ford 1700 (A) has 18% more hydraulic flow (4.5 L/min / 1.2 gpm) than the International Harvester 323 (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?1,730 kg (3,814 lb)Traktorenlexikon, “Ford 1700”No figureNo call on three-point lift: no figure on record for the 323.
Which is heavier, for traction?1,110 kg (2,447 lb)Traktorenlexikon, “Ford 1700”1,876 kg (4,136 lb)Traktorenlexikon, “McCormick 323”Ahead (a fact, not an advantage)The International Harvester 323 is 69% heavier (766 kg / 1,689 lb) than the Ford 1700 (A) (both unladen weight, as stated by the source).
Which may carry more ballast and load?No figureNo call on maximum permissible mass: no figure on record for the 1700 (A) and the 323.
Which has the wider choice of gears?12Traktorenlexikon, “Ford 1700”8 to 16Traktorenlexikon, “McCormick 323”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 1700 (A) and the 323.
Which is faster on the road?20 km/h (12.4 mph)Traktorenlexikon, “Ford 1700”20 km/h (12.4 mph)Traktorenlexikon, “McCormick 323”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Ford 1700”540 rpmTraktorenlexikon, “McCormick 323”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “McCormick 323”No figureNo call on PTO independence: not stated for the 1700 (A).
Which drives on both axles?2WD / 4WDTraktorenlexikon, “Ford 1700”2WDTraktorenlexikon, “McCormick 323”AheadThe Ford 1700 (A) is available with four-wheel drive; the International Harvester 323 is two-wheel drive (as stated by the sources).
Which is newer, and what about parts?1979–19821966–1974Ahead (a fact, not an advantage)The Ford 1700 (A) is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Ford 1700 (A) has 18% more hydraulic flow (4.5 L/min / 1.2 gpm) than the International Harvester 323 (both pump flow, as stated by the source).
  • The International Harvester 323 is 69% heavier (766 kg / 1,689 lb) than the Ford 1700 (A) (both unladen weight, as stated by the source).
  • The Ford 1700 (A) is available with four-wheel drive; the International Harvester 323 is two-wheel drive (as stated by the sources).
  • The Ford 1700 (A) is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources