Fiat TS 90 or New Holland T 5040?

Which should you choose?

The figures split: the Fiat TS 90 is ahead on hydraulic flow; the New Holland T 5040 is ahead on three-point lift.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Fiat TS 90 and New Holland T 5040, with the call on each
QuestionTS 90T 5040Call
Which puts more power through the PTO shaft?56.6 kW (75.9 hp)Traktorenlexikon, “Fiatagri TS90”56.4 kW (75.6 hp)Traktorenlexikon, “New Holland T5040”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the TS 90 and the T 5040.
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the TS 90 and the T 5040.
Which pumps more oil for implements?72.7 L/min (19.2 gpm)Traktorenlexikon, “Fiatagri TS90”66.0 L/min (17.4 gpm)Traktorenlexikon, “New Holland T5040”AheadThe Fiat TS 90 has 10% more hydraulic flow (6.7 L/min / 1.8 gpm) than the New Holland T 5040 (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?4,294 kg (9,467 lb)Traktorenlexikon, “Fiatagri TS90”4,800 kg (10,582 lb)Traktorenlexikon, “New Holland T5040”AheadThe New Holland T 5040 has 12% more lift (506 kg / 1,116 lb) than the Fiat TS 90 (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?3,929 kg (8,662 lb)Traktorenlexikon, “Fiatagri TS90”3,805 kg (8,389 lb)Traktorenlexikon, “New Holland T5040”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?6,000 kg (13,228 lb)Traktorenlexikon, “Fiatagri TS90”6,200 kg (13,669 lb)Traktorenlexikon, “New Holland T5040”EvenEven on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
Which has the wider choice of gears?12 to 24Traktorenlexikon, “Fiatagri TS90”12 to 24Traktorenlexikon, “New Holland T5040”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the TS 90 and the T 5040.
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri TS90”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “New Holland T5040”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Fiatagri TS90”540/540E/1000 rpmTraktorenlexikon, “New Holland T5040”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Fiatagri TS90”independentTraktorenlexikon, “New Holland T5040”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Fiatagri TS90”2WD / 4WDTraktorenlexikon, “New Holland T5040”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1997–20032008–2012Ahead (a fact, not an advantage)The New Holland T 5040 is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Fiat TS 90 has 10% more hydraulic flow (6.7 L/min / 1.8 gpm) than the New Holland T 5040 (both pump flow, as stated by the source).
  • The New Holland T 5040 has 12% more lift (506 kg / 1,116 lb) than the Fiat TS 90 (both lift at the hitch ends, as stated by the source).
  • The New Holland T 5040 is newer: production began 11 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on maximum permissible mass (both maximum permissible mass, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power and a creeper range.

← Every figure for both machines, side by side, with sources