10 material differences · fewer than 12
Tractor oneFiat TS 100 (DT)1997–2003No measured PTO figureTractor twoVALMET 9001997–2002No measured PTO figure
Which should you choose?
Read our verdict on the TS 100 (DT) and the 900 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | TS 100 (DT) | 900 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 88.8 hp | 88.8 hp | — |
| Engine declared | New Holland 450 T/PF | VALMET 420 DS or DSRE | differs |
| Displacement declared | 4.99 L | 4.40 L | +13% TS 100 (DT) |
| Maximum torque declared | 277 lb·ft · 375 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | — | dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Constant flow | — |
| Pump flow declared | 22.7 gpm · 86.0 L/min | 14.7 gpm · 55.7 L/min | +54% TS 100 (DT) |
| Pressure declared | 2,857 psi · 197 bar | 2,901 psi · 200 bar | — |
| Three-point lift, at the coupling points declared | 9,467 lb · 4,294 kg | 7,419 lb · 3,365 kg | +28% TS 100 (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540E/540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,662 lb · 3,929 kg | 7,408 lb · 3,360 kg | +17% TS 100 (DT) |
| Maximum permissible mass declared | 13,228 lb · 6,000 kg | — | — |
| Wheelbase declared | 91.7 in · 2,330 mm | 88.3 in · 2,244 mm | — |
| Length declared | 150.0 in · 3,810 mm | 152.6 in · 3,877 mm | — |
| Width declared | 85.8–96.7 in · 2,180–2,455 mm | 85.7 in · 2,177 mm | differs |
| Ground clearance declared | 17.7 in · 450 mm | 19.9 in · 505 mm | +12% 900 |
| Turning radius, braked declared | 10.8 ft · 3.30 m | 15.7 ft · 4.80 m | +45% 900 |
| Fuel tank declared | 169.1 qt · 160.0 L | 83.5 qt · 79.0 L | +103% TS 100 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat TS 100 (DT) sources
- Source: Traktorenlexikon, “Fiatagri TS100”
VALMET 900 sources
- Source: Traktorenlexikon, “Valmet 900/II”
- Source: Traktorenlexikon, “Valmet 800”