8 material differences · fewer than 12
Tractor oneFiat TN 75 D (DT)1999–2004No measured PTO figureTractor twoNew Holland TN 70 DA/SA2003–2008No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (34%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | TN 75 D (DT) | TN 70 DA/SA | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 71 hp | 71 hp | — |
| Engine declared | New Holland-Iveco 8035.25 | IVECO 8045.05 | differs |
| Displacement declared | 2.93 L | 2.93 L | — |
| Maximum torque declared | 202 lb·ft · 274 N·m | 192 lb·ft · 260 N·m | +5% TN 75 D (DT) |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6–24.9 mph · 30–40 km/h | — |
| Clutch declared | — | Dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 12.5 gpm · 47.4 L/min | 12.4 gpm · 47.0 L/min | — |
| Three-point lift, at the coupling points declared | 5,886 lb · 2,670 kg | 5,351 lb · 2,427 kg | +10% TN 75 D (DT) |
| Rear PTO speeds declared | 540/1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,746 lb · 3,060 kg | 5,020 lb · 2,277 kg | +34% TN 75 D (DT) |
| Maximum permissible mass declared | 9,700 lb · 4,400 kg | — | — |
| Wheelbase declared | 83.9 in · 2,130 mm | 81.5 in · 2,070 mm | — |
| Length declared | 156.7 in · 3,980 mm | 141.8 in · 3,601 mm | +11% TN 75 D (DT) |
| Width declared | 72.8–92.5 in · 1,850–2,350 mm | 73.5–95.6 in · 1,867–2,428 mm | — |
| Ground clearance declared | 15.0 in · 380 mm | 13.9 in · 353 mm | +8% TN 75 D (DT) |
| Turning radius, braked declared | 10.5 ft · 3.20 m | — | — |
| Fuel tank declared | 74.0 qt · 70.0 L | 56.0 qt · 53.0 L | +32% TN 75 D (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat TN 75 D (DT) sources
- Source: Traktorenlexikon, “Fiatagri TN75 D”
New Holland TN 70 DA/SA sources
- Source: Traktorenlexikon, “New Holland TN70 DA/SA”