8 material differences · fewer than 12
Tractor oneFiat TL 90 (DT)1998–2004No measured PTO figureTractor twoNew Holland T4.75from 2011No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (51%); they were not built in overlapping years (1998–2004; 2011–2011). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | TL 90 (DT) | T4.75 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 83.9 hp | 84 hp | — |
| Engine declared | New Holland-Iveco 8045.25 | — | — |
| Displacement declared | 3.91 L | — | — |
| Maximum torque declared | 215 lb·ft · 292 N·m | 206 lb·ft · 279.4 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9 mph · 40 km/h | differs |
| Clutch declared | Dry LuK double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Pump flow declared | 15.9 gpm · 60.0 L/min | 12.5 gpm · 47.5 L/min | +26% TL 90 (DT) |
| Pressure declared | 2,103 psi · 145 bar | — | — |
| Rear PTO speeds declared | 540/540E/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 9,315 lb · 4,225 kg | 6,173 lb · 2,800 kg | +51% TL 90 (DT) |
| Maximum permissible mass declared | 13,228 lb · 6,000 kg | 10,582 lb · 4,800 kg | +25% TL 90 (DT) |
| Wheelbase declared | 92.2 in · 2,342 mm | — | — |
| Length declared | 174.4 in · 4,430 mm | 149.3 in · 3,792 mm | +17% TL 90 (DT) |
| Width declared | 79.1–105.7 in · 2,009–2,684 mm | 76.8 in · 1,950 mm | differs |
| Ground clearance declared | 17.3 in · 440 mm | 15.0 in · 380 mm | +16% TL 90 (DT) |
| Turning radius, braked declared | 12.0 ft · 3.65 m | 12.0 ft · 3.66 m | — |
| Fuel tank declared | 121.5 qt · 115.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat TL 90 (DT) sources
- Source: Traktorenlexikon, “Fiatagri TL90”
New Holland T4.75 sources
- Source: Traktorenlexikon, “New Holland T4.75”
- Source: OECD test report 2743, 2013
- Source: OECD test report 2887, 2015
- Source: OECD test report 2887, 2015