Fiat G 190 or Steyr-Case 9200 a?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the G 190 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9200 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Fiat G 190 suits loader and hydraulic implement work better on this data: 105% (5,050 kg / 11,133 lb) more three-point lift.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Fiat G 190 and Steyr-Case 9200 a, with the call on each
QuestionG 1909200 aCall
Which puts more power through the PTO shaft?139.8 kW (187.5 hp)Traktorenlexikon, “Fiatagri G190”139.8 kW (187.5 hp)Traktorenlexikon, “Steyr 9200 a”Not comparableNot comparable on power at the PTO shaft: the G 190 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9200 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the G 190 and the 9200 a.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the G 190 and the 9200 a.
Which pumps more oil for implements?126.1 L/min (33.3 gpm)Traktorenlexikon, “Fiatagri G190”115.1 L/min (30.4 gpm)Traktorenlexikon, “Steyr 9200 a”EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
Which lifts more on the three-point hitch?9,870 kg (21,760 lb)Traktorenlexikon, “Fiatagri G190”4,820 kg (10,626 lb)Traktorenlexikon, “Steyr 9200 a”AheadThe Fiat G 190 has 105% more lift (5,050 kg / 11,133 lb) than the Steyr-Case 9200a (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?8,748 kg (19,286 lb)Traktorenlexikon, “Fiatagri G190”7,901 kg (17,419 lb)Traktorenlexikon, “Steyr 9200 a”Ahead (a fact, not an advantage)The Fiat G 190 is 11% heavier (847 kg / 1,867 lb) than the Steyr-Case 9200a (both unladen weight, as stated by the source).
Which may carry more ballast and load?14,000 kg (30,865 lb)Traktorenlexikon, “Fiatagri G190”—No figureNo call on maximum permissible mass: no figure on record for the 9200 a.
Which has the wider choice of gears?16 to 18Traktorenlexikon, “Fiatagri G190”24Traktorenlexikon, “Steyr 9200 a”AheadThe Steyr-Case 9200a has 33% more forward gears (6 gears) than the Fiat G 190 (both forward gears, as stated by the source).
Which offers a creeper range?—YesTraktorenlexikon, “Steyr 9200 a”No figureNo call on a creeper range: not stated for the G 190.
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Fiatagri G190”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr 9200 a”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?1000 rpmTraktorenlexikon, “Fiatagri G190”540/1000 rpmTraktorenlexikon, “Steyr 9200 a”AheadThe Steyr-Case 9200a offers 540 rpm at the PTO, which the Fiat G 190 does not (as stated by the sources).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Fiatagri G190”independentTraktorenlexikon, “Steyr 9200 a”EvenEven on PTO independence: every PTO is independent.
Which drives on both axles?4WDTraktorenlexikon, “Fiatagri G190”4WDTraktorenlexikon, “Steyr 9200 a”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1993–20021997–1999EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Fiat G 190 has 105% more lift (5,050 kg / 11,133 lb) than the Steyr-Case 9200a (both lift at the hitch ends, as stated by the source).
  • The Fiat G 190 is 11% heavier (847 kg / 1,867 lb) than the Steyr-Case 9200a (both unladen weight, as stated by the source).
  • The Steyr-Case 9200a has 33% more forward gears (6 gears) than the Fiat G 190 (both forward gears, as stated by the source).
  • The Steyr-Case 9200a offers 540 rpm at the PTO, which the Fiat G 190 does not (as stated by the sources).
  • Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO independence: every PTO is independent.
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the G 190 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 9200 a has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.

← Every figure for both machines, side by side, with sources