Fiat 980 (DT) or Renault 103-12 TX?
Which should you choose?
On performance, every comparable figure that differs favours the Renault 103-12 TX: hydraulic flow and three-point lift. On features, the Fiat 980 (DT) is ahead on drive.
- The Renault 103-12 TX suits loader and hydraulic implement work better on this data: 26% (8.4 L/min / 2.2 gpm) more hydraulic flow and 22% (750 kg / 1,653 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 980 (DT) | 103-12 TX | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 59.6 kW (79.9 hp)Traktorenlexikon, “Fiat 980 DT” | 59.0 kW (79.1 hp)Traktorenlexikon, “Renault 103-12 TX R7812” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 980 (DT) and the 103-12 TX. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 980 (DT) and the 103-12 TX. |
| Which pumps more oil for implements? | 31.8 L/min (8.4 gpm)Traktorenlexikon, “Fiat 980 DT” | 40.2 L/min (10.6 gpm)Traktorenlexikon, “Renault 103-12 TX R7812” | AheadThe Renault 103-12 TX has 26% more hydraulic flow (8.4 L/min / 2.2 gpm) than the Fiat 980 (DT) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 3,350 kg (7,385 lb)Traktorenlexikon, “Fiat 980 DT” | 4,100 kg (9,039 lb)Traktorenlexikon, “Renault 103-12 TX R7812” | AheadThe Renault 103-12 TX has 22% more lift (750 kg / 1,653 lb) than the Fiat 980 (DT) (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 3,460 kg (7,628 lb)Traktorenlexikon, “Fiat 980 DT” | 4,060 kg (8,951 lb)Traktorenlexikon, “Renault 103-12 TX R7812” | Ahead (a fact, not an advantage)The Renault 103-12 TX is 17% heavier (600 kg / 1,323 lb) than the Fiat 980 (DT) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 980 (DT) and the 103-12 TX. |
| Which has the wider choice of gears? | 12 to 16Traktorenlexikon, “Fiat 980 DT” | 12Traktorenlexikon, “Renault 103-12 TX R7812” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 980 (DT) and the 103-12 TX. |
| Which is faster on the road? | 25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Fiat 980 DT” | 25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Renault 103-12 TX R7812” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “Fiat 980 DT” | 540/1000 rpmTraktorenlexikon, “Renault 103-12 TX R7812” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the 980 (DT) and the 103-12 TX. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Fiat 980 DT” | 2WDTraktorenlexikon, “Renault 103-12 TX R7812” | AheadThe Fiat 980 (DT) is available with four-wheel drive; the Renault 103-12 TX is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1979–1984 | 1981–1986 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Renault 103-12 TX has 26% more hydraulic flow (8.4 L/min / 2.2 gpm) than the Fiat 980 (DT) (both pump flow, as stated by the source).
- The Renault 103-12 TX has 22% more lift (750 kg / 1,653 lb) than the Fiat 980 (DT) (both lift at the hitch ends, as stated by the source).
- The Renault 103-12 TX is 17% heavier (600 kg / 1,323 lb) than the Fiat 980 (DT) (both unladen weight, as stated by the source).
- The Fiat 980 (DT) is available with four-wheel drive; the Renault 103-12 TX is two-wheel drive (as stated by the sources).
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources