6 material differences · fewer than 12
Tractor oneFiat 880 (DT)1975–1980No measured PTO figureTractor twoInternational Harvester Farmall 7561967–1971No measured PTO figure
Which should you choose?
Read our verdict on the 880 (DT) and the Farmall 756 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
6 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 880 (DT) | Farmall 756 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 86.9 hp | 75.0 hp | +16% 880 (DT) |
| Engine declared | O.M.-FIAT CO-3/75 | INTERNATIONAL HARVESTER C-291 | differs |
| Displacement declared | 4.56 L | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% Farmall 756 |
| Clutch declared | Dry Ferodo or LuK double clutch | Pedal operated dry single plate clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 12.0 gpm · 45.5 L/min | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,565 lb · 3,885 kg | 8,699 lb · 3,946 kg | — |
| Maximum permissible mass declared | 12,897 lb · 5,850 kg | — | — |
| Wheelbase declared | 96.5 in · 2,450 mm | 97.5 in · 2,477 mm | — |
| Length declared | 158.3 in · 4,020 mm | 157.0 in · 3,988 mm | — |
| Width declared | 78.0 in · 1,980 mm | 92.0 in · 2,337 mm | +18% Farmall 756 |
| Ground clearance declared | 21.7 in · 550 mm | 21.0 in · 533 mm | — |
| Turning radius, braked declared | 12.4 ft · 3.79 m | 9.2 ft · 2.82 m | +34% 880 (DT) |
| Fuel tank declared | 112.0 qt · 106.0 L | 132.1 qt · 125.0 L | +18% Farmall 756 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 880 (DT) sources
- Source: Traktorenlexikon, “Fiat 880/880 DT”
International Harvester Farmall 756 sources
- Source: Traktorenlexikon, “Farmall Farmall 756”