8 material differences · fewer than 12
Tractor oneFiat 80-66S/80-66 DTS1992–1996No measured PTO figureTractor twoHürlimann H-481 XF1992–2000No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | 80-66S/80-66 DTS | H-481 XF | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 79.0 hp | 79.0 hp | — |
| Engine declared | Fiat 8045.05 | Hürlimann 1000.4 W-3 | differs |
| Displacement declared | 3.91 L | 4.00 L | — |
| Maximum torque declared | 197 lb·ft · 267 N·m | 190 lb·ft · 258 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 24.9 mph · 40 km/h | differs |
| Clutch declared | — | Pedal-operated dry SLH single-plate clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 9.1 gpm · 34.5 L/min | 7.1 gpm · 27.0 L/min | +28% 80-66S/80-66 DTS |
| Pressure declared | — | 2,901 psi · 200 bar | — |
| Rear PTO speeds declared | 540 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,919 lb · 2,685 kg | 5,952 lb · 2,700 kg | — |
| Maximum permissible mass declared | 10,141 lb · 4,600 kg | — | — |
| Wheelbase declared | 90.9 in · 2,310 mm | 82.0 in · 2,082 mm | +11% 80-66S/80-66 DTS |
| Length declared | 150.4 in · 3,820 mm | 149.5 in · 3,797 mm | — |
| Width declared | 95.3 in · 2,420 mm | 61.4–70.1 in · 1,560–1,780 mm | differs |
| Ground clearance declared | 16.1 in · 410 mm | 13.8 in · 350 mm | +17% 80-66S/80-66 DTS |
| Turning radius, braked declared | 12.0 ft · 3.65 m | 12.7 ft · 3.86 m | +6% H-481 XF |
| Fuel tank declared | 77.1 qt · 73.0 L | 74.0 qt · 70.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Fiat 80-66S/80-66 DTS sources
- Source: Traktorenlexikon, “Fiatagri 80-66S/80-66 DTS”
Hürlimann H-481 XF sources
- Source: Traktorenlexikon, “Hürlimann XF 481”
- Source: Traktorenlexikon, “Hürlimann XN 708”